measure cpu load ?
Hi,
I would like to measure the CPU load for some queuing discipline, and only queuing discipline. Is there any tool witch this can be done.
Best regards
Lars Landmark
Student
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 2 lines
I would like to measure the CPU load for some queuing discipline, and only queuing discipline. Is there any tool witch this can be done.
I think you will need to do this indirectly.
Perform an experiment like this:
Setup a test machine. It runs nothing but traffic management.
Push test traffic through the machine.
Observe the machine's CPU load.
You can now derive the relationship between traffic level, traffic mix, traffic type and CPU load, by repeating the experiment with different input variables.
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 9 lines
Quoted 2 lines
I would like to measure the CPU load for some queuing discipline, and only queuing discipline. Is there any tool witch this can be done.
I think you will need to do this indirectly.
Perform an experiment like this:
Setup a test machine. It runs nothing but traffic management.
Quoted 7 lines
Push test traffic through the machine.
Observe the machine's CPU load.
You can now derive the relationship between traffic level, traffic mix, traffic type and CPU load, by repeating the experiment with different input variables.
You can try with ttcp tool.
Srikanth.
------------------------------------------------------------------------
You can did it by wrapping xxx_dequeue routine of the qdisc by calls to TSC counter and accumulate these differences over some time.
I measured CBQ and HTB cpu usage by this way as can be seen at HTB home page.
devik
Quoted 18 lines · Srikanth
Quoted 9 lines
Quoted 2 lines
I would like to measure the CPU load for some queuing discipline, and only queuing discipline. Is there any tool witch this can be done.
I think you will need to do this indirectly.
Perform an experiment like this:
Setup a test machine. It runs nothing but traffic management.
Quoted 7 lines
Push test traffic through the machine.
Observe the machine's CPU load.
You can now derive the relationship between traffic level, traffic mix, traffic type and CPU load, by repeating the experiment with different input variables.
Quoted 9 lines
You can try with ttcp tool.
Srikanth.
------------------------------------------------------------------------
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/