Skip to contentSkip to conversation

teql problem

LARTC Eric Leblond 1 participant 3 messages May 13, 2003

lore
Share & tools
lore
#0 lore raw

Hello,

I've got problem to add a teql qdisc on a ip_gre tunnel interface. (works with ethernet interface)

It does not work after boot, but after some try (with different commands) it began to work. And it is almost persistent because, even if you unload teql and ip_gre modules, it works after reload. reboot is the only thing (I found) that breaks the working state.

I really don't know where to look at. I've done a strace to the command when ok and not ok and I did not see what could happened.

Any help greatly appreciated !

Signature · 2 lines
Eric Leblond <[email protected]>
Regit.org
#1 lore raw
Quoted 4 lines · Eric Leblond

Hello,

I've got problem to add a teql qdisc on a ip_gre tunnel interface. (works with ethernet interface) :

I forget the message :

# tc qdisc add dev neta root teql0
RTNETLINK answers: Invalid argument

BR,

Signature · 2 lines
Eric Leblond <[email protected]>
Regit.org
#2 lore raw
In reply to Eric Leblond
Quoted 5 lines · Eric Leblond
Quoted 4 lines · Eric Leblond

Hello,

I've got problem to add a teql qdisc on a ip_gre tunnel interface. (works with ethernet interface) :

For those who can be interested by the answer :
taken from the source code of teql :
1. Slave devices MUST be active devices, i.e., they must raise the tbusy signal and generate EOI events. If you want to equalize virtual
devices like tunnels, use a normal eql device.

Signature · 2 lines
Eric Leblond <[email protected]>
Regit.org