Skip to contentSkip to conversation

NEWBIE Linux Routing Problem?

LARTC Stef Coene 2 participants 2 messages May 27, 2003 – May 28, 2003

lore
Share & tools
lore

Stef Coene

author
#0 lore raw
Quoted 36 lines · Karotu Tannang

Hi All !

I've been running into some minor problems with a linux box we installed as a Domain.

The linux server serves two networks as follows:

        192.168.1.0/25 on eth0
        192.168.128/25 on eth1

The good thing is that all machines on both networks can SEE each other including 'pinging' each other.

After installing an Win 95 Internet Gateway on 192.168.1.2 ... only machines in the 192.168.1.0/25 network can use it to connect to the internet but not the ones in the 192.168.1.128/25 network.

I've also done some reading on lartc.org but couldn't get any help... or maybe its just too complicated for me :( but I've included some info from our server as a result of my readings which I thought would be helpful..

ip route list table main
192.168.1.0/25 dev eth0 scope link
192.168.1.128/25 dev eth0 scope link
127.0.0.0/8 dev lo scope link

ip route table local
local 192.168.1.1 dev eth0 proto kernel scope host src 192.168.1.1 broadcast 192.168.1.0 dev eth0 proto kernel scope link src 192.168.1.1 broadcast 127.255.255.0 dev lo proto kernel scope link src 127.0.0.1 local 192.168.1.129 dev eth1 proto kernel scope host src 192.168.1.129 broadcast 192.168.1.128 dev eth1 proto kernel scope link src 192.168.1.129 broadcast 192.168.1.255 dev eth1 proto kernel scope link src 192.168.1.129 broadcast 192.168.1.127 dev eth0 proto kernel scope link src 192.168.1.1 local 127.0.0.1 dev lo proto kernel scope host 127.0.0.1
local 127.0.0.0/8 dev lo proto kernel scope host 127.0.0.1

Quoted 3 lines

If anyone could kindly offer me some pointers on how to get the other network to connect to the internet via the Internet Gateway, I would be very grateful.

This is maybe a stupid answer, but have the enabled forwarding int he kernel ? echo "1" > /proc/sys/net/ipv4/ip_forward

Stef

Signature · 8 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
     #lartc @ irc.oftc.net

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
#1 lore raw

Hi All !

I've been running into some minor problems with a linux box we installed as a Domain.

The linux server serves two networks as follows:

        192.168.1.0/25 on eth0
        192.168.128/25 on eth1

The good thing is that all machines on both networks can SEE each other including 'pinging' each other.

After installing an Win 95 Internet Gateway on 192.168.1.2 ... only machines in the 192.168.1.0/25 network can use it to connect to the internet but not the ones in the 192.168.1.128/25 network.

I've also done some reading on lartc.org but couldn't get any help... or maybe its just too complicated for me :( but I've included some info from our server as a result of my readings which I thought would be helpful..

ip route list table main
192.168.1.0/25 dev eth0 scope link
192.168.1.128/25 dev eth0 scope link
127.0.0.0/8 dev lo scope link

ip route table local
local 192.168.1.1 dev eth0 proto kernel scope host src 192.168.1.1 broadcast 192.168.1.0 dev eth0 proto kernel scope link src 192.168.1.1 broadcast 127.255.255.0 dev lo proto kernel scope link src 127.0.0.1 local 192.168.1.129 dev eth1 proto kernel scope host src 192.168.1.129 broadcast 192.168.1.128 dev eth1 proto kernel scope link src 192.168.1.129 broadcast 192.168.1.255 dev eth1 proto kernel scope link src 192.168.1.129 broadcast 192.168.1.127 dev eth0 proto kernel scope link src 192.168.1.1 local 127.0.0.1 dev lo proto kernel scope host 127.0.0.1
local 127.0.0.0/8 dev lo proto kernel scope host 127.0.0.1

If anyone could kindly offer me some pointers on how to get the other network to connect to the internet via the Internet Gateway, I would be very grateful.

Thanks again in advance...

Karotu