Server stop receiving traffic
I've tried hard to find answers to below questions without any luck. Please help me!
1. If I do not specify burst, server stops receiving traffic after 5~10 mins. But if I specify burst value to 1500, the server never dies but the performance is very bad. What would be the best burst rate??
2. If I enter 1500 as burst or cburst, tc show command shows it as 1499. Why is this happening?
#tc class add dev eth0 parent 1:1 classid 1:404 htb rate 14kbit ceil 128kbit quantum 1501 burst 1501 cburst 1501
#tc class show dev eth0
....
class htb 1:404 parent 1:1 prio 0 rate 14Kbit ceil 128Kbit burst 1500b cburst 1500b
....
#tc class add dev eth0 parent 1:1 classid 1:404 htb rate 14kbit ceil 128kbit quantum 1500 burst 1500 cburst 1500
#tc class show dev eth0
....
class htb 1:404 parent 1:1 prio 0 rate 14Kbit ceil 128Kbit burst 1499b cburst 1499b
....
_________________________________________________________________
Surf the net and talk on the phone with Xtra Jetstream @
http://www.xtra.co.nz/products/0,,5803,00.html !
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 6 lines · Jay Lee
I've tried hard to find answers to below questions without any luck. Please help me!
1. If I do not specify burst, server stops receiving traffic after 5~10 mins. But if I specify burst value to 1500, the server never dies but the performance is very bad. What would be the best burst rate??
What is the burst calculated by htb if you specify no burst ? And can you send me your full tc scripts and the output from tc -s -d class show dev ... ?
Quoted 12 lines
2. If I enter 1500 as burst or cburst, tc show command shows it as 1499. Why is this happening?
#tc class add dev eth0 parent 1:1 classid 1:404 htb rate 14kbit ceil 128kbit quantum 1501 burst 1501 cburst 1501
#tc class show dev eth0
....
class htb 1:404 parent 1:1 prio 0 rate 14Kbit ceil 128Kbit burst 1500b cburst 1500b
....
Quoted 7 lines
#tc class add dev eth0 parent 1:1 classid 1:404 htb rate 14kbit ceil 128kbit quantum 1500 burst 1500 cburst 1500
#tc class show dev eth0
....
class htb 1:404 parent 1:1 prio 0 rate 14Kbit ceil 128Kbit burst 1499b cburst 1499b
....
Somehow (my c is not so good) htb recalculates the burst (cburst) and uses the rate (ceil) to do so. The funcion is called tc_calc_xmittime in file tc_core.c (tc source).tc_calc_xmittime = calculate transmit time ???
Stef
Signature · 8 lines
[email protected] "Using Linux as bandwidth manager" http://www.docum.org/ #lartc @ irc.oftc.net _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/