Traffic-shaping at high rates?
Clemens Sibon [email protected]
<PRE>Hi there,
I took home a 100 Mbit hub tonight and without shaping I now get 73 Mbit/sec across the line (I use iperf between my Linux machine and a FreeBSD box). So far, so good. But when I try to get say 20 Mbit outgoing, using:
tc qdisc add dev eth1 root handle 10: cbq bandwidth 100Mbit avpkt 1000
tc class add dev eth1 parent 10:0 classid 10:1 cbq bandwidth 100Mbit \
rate 100Mbit allot 1514 weight 10Mbit prio 8 maxburst 200 avpkt 1000
tc class add dev eth1 parent 10:1 classid 10:200 cbq bandwidth 100Mbit \
rate 20Mbit allot 1514 weight 1Mbit prio 5 maxburst 200 avpkt 1000 bounded
tc qdisc add dev eth1 parent 10:200 sfq quantum 1514b perturb 15
tc filter add dev eth1 parent 10:0 protocol ip prio 100 u32 match ip dst \
0.0.0.0/0 flowid 10:200
I get about 9 to 10 Mbit/sec. When I try to get 50, I get 16. I am experimenting with the other parameters (avpkt, burstsize, weight) but can't find a direct relation (yet). Is there any documentation about what parameter does what and how this influences the througput? Should I use other queuing-algorithms at these rates? I have tried to get RED working but to no avail. It complained about the parameters I tried to feed it...
Well, I'll go on experimenting a bit. I hope there are others that are trying shaping at these rates too,
Clemens Sibon
</PRE>