Skip to contentSkip to conversation

Can't ping another machine.

LARTC Mark Tiller [email protected] 2 participants 2 messages Jan 12, 2001 – Jan 13, 2001

lore
Share & tools
lore

Mark Tiller [email protected]

author
#0 lore raw

<PRE>Dear All,

I'm a newbie to Linux and I'm not sure if this problem is appropriate to
this list, if not, my apologies to the list, however I am beginning to beleive this is a routing problem.

I'm trying to get TCP/IP running on my system, I have a DLINK 530TX, Linux says it running ok, I'm
currently running Corel 1.2 previously Mandrake 7.1 which had exactly the same result (thought I'd try another distrib).

The box can ping itself, but nothing else.

I have the Linux box set as follows:

Ip Addr 192.168.1.1
Netmask 255.255.255.0
Gateway 192.168.1.2

I have a win2k machine connected via a crossover cable that works fine (I can connect the to machines OK when I boot the Linux box into Windows 98 or 2000).

The win2k has TCP/IP set as follows

Ip Addr 192.168.1.2
Netmask 255.255.255.0
NO gateway.

If I try and ping the linux box from WIn2k I get Timeouts.

IF I try to ping the win2k machine from Linux I get no error messages just 100% packet loss.

ifconfig -a shows as follows:

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:3924 Metric:1
RX packets:55 errors:0 dropped:0 overruns:0 frame:0 TX packets:55 errors:0 dropped:0 overruns:0 carrier:0 Collisions:0

eth0 Link encap:Ethernet HWaddr 00:50:BA:07:2F:34 inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0 UP BROADCAST RUNNING MTU:1500 Metric:1
RX packets:8 errors:0 dropped:0 overruns:0 frame:0 TX packets:7 errors:201 dropped:0 overruns:0 carrier:0 Collisions:0
Interrupt:9 Base address:0x6500

Any help anyone can give would be much appreciated.

Thanks in advance.

</PRE>

#1 lore raw

<PRE>On Fri, Jan 12, 2001 at 08:21:50PM -0000, Mark Tiller wrote:

&gt;<i> eth0 Link encap:Ethernet HWaddr 00:50:BA:07:2F:34 </I>&gt;<i> inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0 </I>&gt;<i> UP BROADCAST RUNNING MTU:1500 Metric:1 </I>&gt;<i> RX packets:8 errors:0 dropped:0 overruns:0 frame:0 </I>&gt;<i> TX packets:7 errors:201 dropped:0 overruns:0 carrier:0 </I>&gt;<i> Collisions:0
</I>&gt;<i> Interrupt:9 Base address:0x6500
</I>&gt;<i>
</I>&gt;<i> Any help anyone can give would be much appreciated. </I>
I think you might have 10/100 mbit autonegotiation problems. Try forcing either end to use a setting.

If that doesn't work, run tcpdump -i eth0 under Linux to see if any traffic comes by.

Regards,

bert

Signature · 6 lines
PowerDNS                     Versatile DNS Services  
Trilab                       The Technology People   
'SYN! .. SYN|ACK! .. ACK!' - the mating call of the internet


</PRE>