How to recognize a IPSEC packet ?
Hi all,
I want to make bandwidth management with CBQ (iproute2) There is no problem to manage service like FTP, HTTP,...
We have an IPSEC VPN here, and I don't know how to reconignize IPSEC packets to manage the VPN bandwith.
Is there a special port or something in the IP packet header that tells "here is an IPSEC packet" ?
Thanks,
------------------------------------------------
Franck BALAZOT ([email protected])
AETA.COM
361, Avenue du Général De Gaulle
92140 CLAMART
FRANCE
Tél:01.41.36.12.93
------------------------------------------------
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/
Quoted 9 lines · Franck BALAZOT
Hi all,
I want to make bandwidth management with CBQ (iproute2) There is no problem to manage service like FTP, HTTP,...
We have an IPSEC VPN here, and I don't know how to reconignize IPSEC packets to manage the VPN bandwith.
Is there a special port or something in the IP packet header that tells "here is an IPSEC packet" ?
Yep, ipsec normally uses IP Protocol 50 or 51 depending on other factors...
These numbers aren't ports, but protocols on the same level of tcp and udp.
ipchains -A input -m 1 -p 50 (or some such...)
Mike
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/
Quoted 19 lines · Franck BALAZOT
Hi all,
I want to make bandwidth management with CBQ (iproute2) There is no problem to manage service like FTP, HTTP,...
We have an IPSEC VPN here, and I don't know how to reconignize IPSEC packets to manage the VPN bandwith.
Is there a special port or something in the IP packet header that tells "here is an IPSEC packet" ?Thanks,
------------------------------------------------
Franck BALAZOT ([email protected])
AETA.COM
361, Avenue du Général De Gaulle
92140 CLAMART
FRANCE
Tél:01.41.36.12.93
------------------------------------------------
Quoted 3 lines
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/
Hi,
From what I remember, IPSec use port 500 TCP for IKE & protocol-ids for IPSec trafic are
50 (ESP) / 51 (AH) (stored in IP Header). This should allow you to recognize the IPSec
traffic with u32 filters.
Hope this help !
Later,
Raffaele.
--
____________________________________________________________________________
Raffaele Brancaleoni Email : [email protected]
Licence en Informatique
Université de Liège - Belgique
____________________________________________________________________________
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/