Skip to contentSkip to conversation

Yamaha OPL3-Sax sound card

DISCUSSION Ramon Nieto 5 participants 5 messages Feb 24, 1999 – Feb 25, 1999 Sound

lore
Share & tools
lore
#0 lore raw

i have a Yamaha OPL3-SAx sound card on a toshiba satellite 2500cds. i instaled linux red hat 5.1 and i know this can't recognize the sound card i tried to configure it as a sound blaster but it only play in 8 bits mode, the sound card support 16 bit mode.

So i compiled the 2.2.0 kernel with all the support for sound card as modules. but i can't configure the sound card yet.

anybody knows what to do? what can i write in the conf.modules? how can i use the OSS modules?

BTW the isapnptools don't recognize the sound card as a PnP card.

_________________________________________________________
DO YOU YAHOO!?
Get your free @yahoo.com address at http://mail.yahoo.com

#1 lore raw

I use 2.0.36 kernel on my satellite 2500cds, its works fine. And i use it too on my desktop with opl3-sax.

Don't configure it as SB, it will not working properly, but configure as MSS/WSS will do much better.

if pnpdump don't recognize your sc, try to force it.
boot your system in DOS and run your sc configuration, write down the io, irq, dma, etc. and then instal the modules.

Quoted 6 lines · Ramon Nieto

i have a Yamaha OPL3-SAx sound card on a toshiba satellite 2500cds. i instaled linux red hat 5.1 and i know this can't recognize the sound card i tried to configure it as a sound blaster but it only play in 8 bits mode, the sound card support 16 bit mode.

BTW the isapnptools don't recognize the sound card as a PnP card.

Wima Sangga Y.
--------------
Engineering Physics - ITS

#2 lore raw
In reply to Ramon Nieto

On my Tecra 8000, the manual says that it is a OPL3-SAx card, but the sound modules that seems to power it is the MSS module.

I havent played with it too much, but I do know that the MSS module does play 16bit sound through the card.

-Adam

On Wed, 24 Feb 1999, Ramon Nieto wrote:

  | Date: Wed, 24 Feb 1999 08:46:29 -0800 (PST)
  | From: Ramon Nieto <[email protected]>
  | To: [email protected]
  | Cc: [email protected]
  | Subject: Yamaha OPL3-Sax sound card
  | 
  | i have a Yamaha OPL3-SAx sound card on a toshiba satellite 2500cds. 
  | i instaled linux red hat 5.1 and i know this can't recognize the sound
  | card i tried to configure it as a sound blaster but it only play in 8
  | bits mode, the sound card support 16 bit mode.
  | 
  | So i compiled the 2.2.0 kernel with all the support for sound card as
  | modules. but i can't configure the sound card yet.
  | 
  | anybody knows what to do? what can i write in the conf.modules? how
  | can i use the OSS modules?
  | 
  | 
  | BTW the isapnptools don't recognize the sound card as a PnP card.
  | 
  | 
  | 
  | 
  | _________________________________________________________
  | DO YOU YAHOO!?
  | Get your free @yahoo.com address at http://mail.yahoo.com
  | 
#3 lore raw
In reply to Ramon Nieto

AFAIK, Yamaha OPL3sa emulated Windows Sound System(MSS), SoundBlaster Pro and MPU401. You may enable all of'em to get sound works properly.

-jin

Quoted 30 lines · Adam Crews

On my Tecra 8000, the manual says that it is a OPL3-SAx card, but the sound modules that seems to power it is the MSS module.

I havent played with it too much, but I do know that the MSS module does play 16bit sound through the card.

-Adam

On Wed, 24 Feb 1999, Ramon Nieto wrote:

  | Date: Wed, 24 Feb 1999 08:46:29 -0800 (PST)
  | From: Ramon Nieto <[email protected]>
  | To: [email protected]
  | Cc: [email protected]
  | Subject: Yamaha OPL3-Sax sound card
  | 
  | i have a Yamaha OPL3-SAx sound card on a toshiba satellite 2500cds. 
  | i instaled linux red hat 5.1 and i know this can't recognize the sound
  | card i tried to configure it as a sound blaster but it only play in 8
  | bits mode, the sound card support 16 bit mode.
  | 
  | So i compiled the 2.2.0 kernel with all the support for sound card as
  | modules. but i can't configure the sound card yet.
  | 
  | anybody knows what to do? what can i write in the conf.modules? how
  | can i use the OSS modules?
  | 
  | 
  | BTW the isapnptools don't recognize the sound card as a PnP card.
Quoted 9 lines
  | 
  | 
  | 
  | 
  | _________________________________________________________
  | DO YOU YAHOO!?
  | Get your free @yahoo.com address at http://mail.yahoo.com
  | 

-----------------------------------------------------------------
Jin Ko mailto:[email protected]
Network Engineer http://ghost.nuri.net/
International Backbone Group phone:+82-2-531-7924
Inet, Inc. -- a PSINet Company in Korea fax:+82-2-555-8127

#4 lore raw
In reply to Ramon Nieto

I''m using the same sound chip in my Gateway Laptop and ended up using th OSS driver from http://www.opensound.com/

Quoted 47 lines · Jin Ko

AFAIK, Yamaha OPL3sa emulated Windows Sound System(MSS), SoundBlaster Pro and MPU401. You may enable all of'em to get sound works properly.

-jin

Quoted 30 lines · Adam Crews

On my Tecra 8000, the manual says that it is a OPL3-SAx card, but the sound modules that seems to power it is the MSS module.

I havent played with it too much, but I do know that the MSS module does play 16bit sound through the card.

-Adam

On Wed, 24 Feb 1999, Ramon Nieto wrote:

  | Date: Wed, 24 Feb 1999 08:46:29 -0800 (PST)
  | From: Ramon Nieto <[email protected]>
  | To: [email protected]
  | Cc: [email protected]
  | Subject: Yamaha OPL3-Sax sound card
  |
  | i have a Yamaha OPL3-SAx sound card on a toshiba satellite 2500cds.
  | i instaled linux red hat 5.1 and i know this can't recognize the sound
  | card i tried to configure it as a sound blaster but it only play in 8
  | bits mode, the sound card support 16 bit mode.
  |
  | So i compiled the 2.2.0 kernel with all the support for sound card as
  | modules. but i can't configure the sound card yet.
  |
  | anybody knows what to do? what can i write in the conf.modules? how
  | can i use the OSS modules?
  |
  |
  | BTW the isapnptools don't recognize the sound card as a PnP card.
Quoted 9 lines
  |
  |
  |
  |
  | _________________________________________________________
  | DO YOU YAHOO!?
  | Get your free @yahoo.com address at http://mail.yahoo.com
  |
Quoted 5 lines

-----------------------------------------------------------------
Jin Ko mailto:[email protected]
Network Engineer http://ghost.nuri.net/
International Backbone Group phone:+82-2-531-7924
Inet, Inc. -- a PSINet Company in Korea fax:+82-2-555-8127

--
----------------------------------------------------------
Work in progress, please be gentle...
----------------------------------------------------------

Brent Williams
[email protected]
PGP Key -- http://www.palenaka.com/pgp/palenaka.asc