ensoniq 1371
i have an ensoniq 1371 card that has in the past worked perfectly fine with RH5.2 and 6.0. i just downgraded from 6.0 to 5.2 for other reasons and when i run sndconfig i get:
The following error occurred
running the modprobe program:
<it's blank>
any ideas?
is there a way to set it up manually. when i try the utility's "manual" mode i get the same error.
----------------------------------
E-Mail: [email protected]
Date: 13-Jun-99
Time: 00:13:38
This message was sent by XFMail
----------------------------------