Skip to contentSkip to conversation

OMAP: sDMA: DMA : DMA spurious IRQ in shared usage

PATCH New Shilimkar, Santosh 2 participants 2 messages Feb 4, 2009 – Feb 27, 2009

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 OMAP: sDMA: DMA : DMA spurious IRQ in shared usage

Tony,
Here is the second patch which fixes the spurious irq issue on sDMA when used by two software modules with independent interrupt lines.

From: Santosh Shilimkar <[email protected]>

This fixes the spurious interrupt issue on a DMA channel.

In OMAP sDMA, contrast to the SDMA.DMA4_CSRi registers, the SDMA.DMA4_IRQSTATUS_Lj registers are updated regardless of the corresponding bits in the SDMA.DMA4_IRQENABLE_Lj registers. Since there are four sDMA interrupt lines and if more than one line is actively used by two concurrently running sDMA softwares modules,then the spurious interrupt can be observed on the other
lines.

Fix in this patch will only dispatch the relevant and enabled interrupts on a particular line thus perevting spurious IRQ.

Acked By: Nishant Kamat <[email protected]>
cc: Tony Lindgren <[email protected]>

---
 arch/arm/plat-omap/dma.c |    8 +++++---
 1 files changed, 5 insertions(+), 3 deletions(-)
arch/arm/plat-omap/dma.c +3 -1
Index: omapkernel/arch/arm/plat-omap/dma.c
===================================================================
@@ -1954,7 +1954,7 @@ static int omap2_dma_handle_ch(int ch)
 /* STATUS register count is from 1-32 while our is 0-31 */
 static irqreturn_t omap2_dma_irq_handler(int irq, void *dev_id)
 {
-	u32 val;
+	u32 val, enable_reg;
 	int i;
 
 	val = dma_read(IRQSTATUS_L0);
@@ -1963,6 +1963,8 @@ static irqreturn_t omap2_dma_irq_handler
 			printk(KERN_WARNING "Spurious DMA IRQ\n");
 		return IRQ_HANDLED;
 	}
+	enable_reg = dma_read(IRQENABLE_L0);
+	val &= enable_reg; /* Dispatch only relevant interrupts */
 	for (i = 0; i < dma_lch_count && val != 0; i++) {
 		if (val & 1)
 			omap2_dma_handle_ch(i);

Regards,
Santosh