Linux booting problems in the IBM Bubinga Board
Yes, I tried both with and without the console= argument, selecting ttyS0 and baud 9600. Same result.
Quoted 1 line
Quoted 1 line
Quoted 1 line
Wolfgang Denk <[email protected]> 08/04/04 05:03PM >>>
Quoted 2 lines · In message <[email protected]> you wrote:
I am using U-boot to boot linux kernel on the IBM Bubinga (405EP board). Using kernel version 2.6.7, which has a default config file for this board. Changed the board info structure to match u-boot's board information structure. Using the mkimage utilit
PLEASE don't use such long lines. Press ENTER after some 60...70 characters or so.
Quoted 1 line
ach_depcalls output some messages. This tells me that code reaches instart_kernel, however, afterconsole_init, the serial port dies. I assume this is because we initialize the serial port, and turn off early debug. I commented o
Did you pass some "console=..." boot argument?
Best regards,
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: [email protected] One difference between a man and a machine is that a machine is quiet when well oiled.
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/