Using pvcreate with file...

connect "vm1disk" file to "/dev/loop0" device:

# losetup /dev/loop0 vm1disk
display info about /dev/loop0:
# losetup /dev/loop0
use it to create pv:
# pvcreate /dev/loop0

later delete the /dev/loop0 <-> vm1disk binding by issuing command:

# losetup -d /dev/loop0
(do it after "pvremove /dev/loop0")

cheers,
bartek

Hello,

I am newbe to the lvm and I have the following issue:
My system is partitioned in the following way:

===============================================================

   Device Boot      Start         End      Blocks   Id  System
/dev/hda1   *           1          16      128488+  83  Linux
/dev/hda2              17        4767    38162407+  83  Linux
/dev/hda3            4768        4865      787185   82  Linux swap

===============================================================
There is no free space left on the disk.

I created the separate files, which I want to be lvm-enabled; I used the following commands:

==============================================================
#> cd /
#> dd if=/dev/zero of=vm1disk bs=1k seek=16384k count=1 #> mkfs -t ext3 vm1disk

#> dd if=/dev/zero of=vm1swap bs=1024k count=1
#> mkswap vm1swap
==============================================================

Now I want to initialize that "disk" for lvm-use.
So what I need to do?

pvcrete ..........................?

I had a look at the documentation, but they deal with real partitions and disks (as far as I understood), not with files...

Thanks in advance to everyone who responds,
Arsen.

_______________________________________________
linux-lvm mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/linux-lvm
read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/