Skip to contentSkip to conversation

YMF753 AC '97 Module Options

DISCUSSION David Shust 2 participants 2 messages Sep 24, 2002 – Sep 25, 2002

lore
Share & tools
lore
#0 lore raw
Quoted 4 lines

Takashi Iwai wrote
the patch looks good except for the module options for spdif. since ac97_codec is a generic module, it's better to avoid such device specific options. isn't it detectable?

If the Yamaha YMF753 spec provided a way to autodetect which pin was being used for S/PDIF ouput, I'd use it.

The alternative to providing a module parameter via insmod would be to provide a mixer control, where one would have the choice of disabling S/PDIF output, or selecting pin 43 or 48. My instincts told me that it made more sense having this as a module parameter, as once one has determined which pin is being used, why would one ever change that value. I felt the same about the parameter for adding the delay after DAC startup in order to avoid missing audio. I could make both items mixer controls if both Jaroslav and Takashi feel it is better. Could you both please respond?

Regards,
David Shust

------------------------------------------------------------
Free, BeOS-friendly email accounts: http://BeMail.org/
BeOS News and Community: http://www.BeGroovy.com/

---------------------------------------------------------------------
Express yourself with a super cool email address from BigMailBox.com. Hundreds of choices. It's free!
http://www.bigmailbox.com
---------------------------------------------------------------------

-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf

#1 lore raw

At Tue, 24 Sep 2002 10:44:58 -0700,

Quoted 8 lines · David Shust
Quoted 5 lines

Takashi Iwai wrote
the patch looks good except for the module options for spdif. since ac97_codec is a generic module, it's better to avoid such device specific options. isn't it detectable?

If the Yamaha YMF753 spec provided a way to autodetect which pin was being used for S/PDIF ouput, I'd use it.

ok. then user must choose.

Quoted 9 lines

The alternative to providing a module parameter via insmod would be to provide a mixer control, where one would have the choice of disabling S/PDIF output, or selecting pin 43 or 48. My instincts told me that it made more sense having this as a module parameter, as once one has determined which pin is being used, why would one ever change that value. I felt the same about the parameter for adding the delay after DAC startup in order to avoid missing audio. I could make both items mixer controls if both Jaroslav and Takashi feel it is better. Could you both please respond?

the problem is, as mentioned in my last mail, ac97-codec is a generic module which is shared among drivers.
for example, what happens if you have two cards with the ymf753? so, if this parameter is implemented as a module option, then it should go into the card module and store the value in ac97 struct, e.g. ac97->spec.ymf753.spdif_out_pin and spdif_delay.
or, as you wrote above, implement this as a control switch. it's not too bad, because with this switch you can disable spdif output on the fly, too.

Takashi

-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf