Skip to contentSkip to conversation

Names of things

DISCUSSION Tom Watson 2 participants 2 messages Oct 8, 2003 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

Tom Watson

author
#1 lore raw

A message a while ago mentioned the difficulty in the "proper" names for things. While the terms "left" and "right" have been around for a while, other terms are new to the show. For instance "master" and "headphone" mean weird things. In an effort to make things "easier", I would like to suggest:

"Front" and "Back". While "Front" is very obvious, "Back" may not be intuitive (others preferring "Rear"). The problem is that many people abbreviate channels by their initials, and "R" is already taken ("Right"), so "Back" is a better choice. Besides, when 4-channel stereo was being discussed/standardized back in the 70's, they made that choice.

I also support the decision to make "Master" refer to a common control for many levels (more than 2 channels).

I would also like to have a "note" explain somewhere that "LFE" is a synonym for "Sub_woofer"

Just a few comments. Alsa is the BEST!

=====

Signature · 13 lines
Tom Watson
[email protected]

__________________________________
Do you Yahoo!?
The New Yahoo! Shopping - with improved product search
http://shopping.yahoo.com


-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf
#2 lore raw

At Wed, 8 Oct 2003 00:07:57 -0700 (PDT),

Quoted 5 lines · Tom Watson

A message a while ago mentioned the difficulty in the "proper" names for things. While the terms "left" and "right" have been around for a while, other terms are new to the show. For instance "master" and "headphone" mean weird things.

yes, "headphone" is used often in a wrong way.
this control appears usually on ac97 chips. and the recent ac97 chips provide the former headphone output as the "true line-out" pin for the consumer device. hence, nowdays, most implementation uses headphone output as the real line-out instead of the old line-out pin.

OTOH, "headphone" in emu10k1 driver refers really to a headphone jack, for example.

Quoted 9 lines

In an effort to make things "easier", I
would like to suggest:

"Front" and "Back". While "Front" is very obvious, "Back" may not be intuitive (others preferring "Rear"). The problem is that many people abbreviate channels by their initials, and "R" is already taken ("Right"), so "Back" is a better choice. Besides, when 4-channel stereo was being discussed/standardized back in the 70's, they made that choice.

so far, "Surround" (or "Rear") is used for that.
it it too amgibuous?

Quoted 2 lines

I also support the decision to make "Master" refer to a common control for many levels (more than 2 channels).

well, my understanding of "master" is that it's a controll for all over other controls. i.e. if you change "master", all outputs should be affected.

Takashi

-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf