Linux 2.2.1 Kernel scsi troubles
I used to have the same problem on my first-gen. G3 tower when I used to boot with a floppy/OF combo and 2.1.24. When I switched to BootX (thanks a billion, Ben H.) + 2.1.125 (and 2.1.130 and 2.2.0 consequently), the problems disappeared.
Quoted 1 line
Quoted 1 line
Quoted 1 line
Piotr Muszynski <[email protected]> - 2/13/99 6:54 AM >>>
I have the same problem (aborting MESH target) on my 7500/601/100MHz/64MB with 2 disks, linuxppc r4:
binutils-2.9.1-19a
modutils-2.1.121-1
egcs-1.1-1b
egcs-c++-1.1-1b
egcs-as-gcc-1.1-1b
egcs-fixes-1-1
glibc-0.961212-1o
glibc-devel-0.961212-1o
glibc-static-0.961212-1o
/dev/sda -- MacOS, with BootX/vmlinux (Fireball) --> this one's
aborted/dev/sdb -- half MacOS, half Linux (IBM)
Attached devices:
Host: scsi0 Channel: 00 Id: 00 Lun: 00
Vendor: QUANTUM Model: FIREBALL1280S Rev: 630G
Type: Direct-Access ANSI SCSI revision: 02
Host: scsi0 Channel: 00 Id: 01 Lun: 00
Vendor: IBM Model: DCAS-32160 Rev: S65A
Type: Direct-Access ANSI SCSI revision: 02
Host: scsi0 Channel: 00 Id: 03 Lun: 00
Vendor: SONY Model: CD-ROM CDU-8005 Rev: 1.0j
Type: CD-ROM ANSI SCSI revision: 02
Is there anything I could help with?
BTW, vmlinux by Paul displayed only the welcome line. 2.2.1 boots further (until failing on MESH) only after adding #ifdef __SMP__ / #endif to arch/ppc/kernel/head.S (lines 1208/1212).
piotru
[[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. To unsubscribe from linuxppc-dev, send ]] [[ the message 'unsubscribe' to [email protected] ]]