Skip to contentSkip to conversation

PCI Subsystem

DISCUSSION Tyler BIRD 1 participant 1 message Dec 11, 2001

lore
Share & tools
lore

Tyler BIRD

author
#0 lore raw

You probably could compile your drivers as modules and load them
with io ports on the command line. Then they would for sure use the right ports. I don't know why you aren't receiving the correct io/ports from the PCI Config Address Space does your driver take advantage of the the PCI standard

Quoted 1 line
Quoted 1 line
Quoted 1 line

Jens Krüger <[email protected]> 12/11/01 05:26AM >>>

Hi,
I have a little problem with the PCI subsystem. I tried to use two cards of the Meilhaus Co.. If I use the PCI access mode 'any' I don't get the right I/O ports of the cards. Next I tried the access mode 'Direct' ( the output of the lspci -v command is listed in the attached file lspci.direct) and the access mode 'BIOS' (the output is stored in the file lspci.bios). There are some little differences in the output, but all seems the same except the output of the two Meilhaus cards. I have no idea for this behaviour. I tried these cards under DOS and I got the same information as for the BIOS access mode (the programm access the BIOS too), but in this mode all other cards especially network card and USB don't work, so I can't use this mode. My
question: Is there any idea (or hack) to solve this problem?

With regards

Jens

Signature · 11 lines
Jens Krnger

Technische UniversitSt Mnnchen
ZBE FRM-II
Lichtenberg-Str. 1
D-85747 Garching

Tel: + 49 89 289 14 716
Fax: + 49 89 289 14 666
mailto:[email protected] 
http://www.frm2.tu-muenchen.de