Skip to contentSkip to conversation

iptables rules for forwarding remote desktop

DISCUSSION Steve Howard 1 participant 1 message Nov 6, 2002

lore
Share & tools
lore
#0 lore raw

Thank you very much,

I tried those three rules, I even flushed all the other rules and saved. This still is not working.

I can scan the Linux machine with nmap and it does not show port 3389. I can scan the windows machine and it does show the port 3389.

Should the port 3389 show up on a nmap scan of the Linux machine?

Quoted 1 line
Quoted 1 line
Quoted 1 line

Antony Stone <[email protected]> 11/06/02 01:56PM >>>

Quoted 8 lines · Steve Howard

I have a RedHat 8 machine with 2 ethernet cards. eth0 is connected via dhcp to the Internet (cable modem). eth1 is private 192.168.1.1. I have a windows xp machine which I have set up to acquire a dhcp address, (it is always 192.168.1.10). I would like to be able to use the remote desktop (port 3389) from outside. I understand that I will have to forward port 3389 to eth0 so that I can access this port from my office machine. I have seen recommendations of one rule, and I have seen recommendations that have three rules listed. Can anyone help me get this right?

iptables -A PREROUTING -t nat -i eth0 -p tcp --dport 3389 -j DNAT --to 192.168.1.10
iptables -A FORWARD -m state --state ESTABLISHED,RELATED -j ACCEPT iptables -A FORWARD -i eth0 -s a.b.c.d -p tcp --dport 3389 -j ACCEPT

where a.b.c.d is the address of your office machine - otherwise anyone will be able to access your xp desktop :-)

I assume this service runs on TCP port 3389 - if it's UDP for some reason, simply change both instances of tcp to udp in the rules above.

Antony.

Signature · 5 lines
All matter in the Universe can be placed into one of two categories:

1. things which need to be fixed
2. things which will need to be fixed once you've had a few minutes to play 
with them