SIS900 module detects two transceivers, picks the wrong one
Quoted 1 line
Quoted 1 line
Quoted 1 line
"Richard B. Johnson" [email protected]> 02/03/03 03:12PM >>
Thanks for the quick response, Richard!
Quoted 6 lines
Perhaps dmesg will explain better:
eth0: AMD79C901 HomePNA PHY transceiver found at address 2.
eth0: AMD79C901 10BASE-T PHY transceiver found at address 3.
eth0: using transceiver found at address 2 as default
eth0: SiS 900 PCI Fast Ethernet at0xec400, IRQ 11,
00:30:67:09:53:81.
Quoted 2 lines
This looks as though your wire is just connected backwards, i.e., you have a reversed patch-cord.
The patch cable I've got has worked on other machines and hub set up for 10Base-T.
Quoted 2 lines
Are you connected to a Hub? Does the LED on the hub show that the wire is connected properly an does the LED on/near the connector
on
Quoted 1 line
your PC show that its connected correctly also?
Both the hub and the PC show link lights when connected, yes. The hub is 10Base-T also.
Quoted 2 lines
If you really do have to such connectors, just use eth1 instead of eth0, i.e.,
ifconfig eth1 ip-address ...
I will certainly give this a try. It's turning out to be quite an experience in how the Linux kernel thinks of devices. :) I don't really care which eth port it uses, as long as it works.
So my ifconfig would be:
ifconfig eth1 address 192.168.0.4 netmask 255.255.255.0
- right?
I'm curious though - does ipconfig actually *create* the device ethx? Isn't that what the SIS900 module is doing -- detecting a device and mapping it onto eth0? dmesg does not reveal a similar report for eth1. In that case, how do I force it to use the transceiver at address 3 (see the dmesg above), or will it decide to use that one automatically? Sorry for my ignorance.
Thanks very much,
Cameron Goble