Skip to contentSkip to conversation

firewire: fw-sbp2: fix refcounting

PATCH New Stefan Richter 1 participant 2 messages Nov 7, 2007 10 messages not in the archive Firewire

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

#10 lore raw

PATCH 1/2 firewire: fw-sbp2: fix refcounting

Since patch "fw-sbp2: use an own workqueue (fix system responsiveness)" increased parallelism between fw-sbp2 and fw-core, it was possible that fw-sbp2 didn't release the SCSI device when the FireWire device was disconnected.

This happened if sbp2_update() ran during sbp2_login(), because a bus reset occurred during sbp2_login(). The sbp2_login() work would [try to] reschedule itself because it failed due to the bus reset, and it would _not_ drop its reference on the target. However, sbp2_update() would schedule sbp2_login() too before sbp2_login() rescheduled itself and hence sbp2_update() would take an additional reference. And then we would have one reference too many.

The fix is to _always_ drop the reference when leaving the sbp2_login() work. If the sbp2_login() work reschedules itself, it takes a reference, but only if it wasn't already rescheduled by sbp2_update().

Ditto in the sbp2_reconnect() work.

The resulting code is actually simpler than before: We _always_ take a reference when successfully scheduling work. And we _always_ drop a reference when leaving a workqueue job. No exceptions.

---
 drivers/firewire/fw-sbp2.c |   11 +++++++----
 1 file changed, 7 insertions(+), 4 deletions(-)
drivers/firewire/fw-sbp2.c +7 -4
Index: linux/drivers/firewire/fw-sbp2.c
===================================================================
@@ -650,13 +650,14 @@ static void sbp2_login(struct work_struc
 	if (sbp2_send_management_orb(lu, node_id, generation,
 				SBP2_LOGIN_REQUEST, lu->lun, &response) < 0) {
 		if (lu->retries++ < 5) {
-			queue_delayed_work(sbp2_wq, &lu->work,
-					   DIV_ROUND_UP(HZ, 5));
+			if (queue_delayed_work(sbp2_wq, &lu->work,
+					       DIV_ROUND_UP(HZ, 5)))
+				kref_get(&lu->tgt->kref);
 		} else {
 			fw_error("failed to login to %s LUN %04x\n",
 				 unit->device.bus_id, lu->lun);
-			kref_put(&lu->tgt->kref, sbp2_release_target);
 		}
+		kref_put(&lu->tgt->kref, sbp2_release_target);
 		return;
 	}
 
@@ -914,7 +915,9 @@ static void sbp2_reconnect(struct work_s
 			lu->retries = 0;
 			PREPARE_DELAYED_WORK(&lu->work, sbp2_login);
 		}
-		queue_delayed_work(sbp2_wq, &lu->work, DIV_ROUND_UP(HZ, 5));
+		if (queue_delayed_work(sbp2_wq, &lu->work, DIV_ROUND_UP(HZ, 5)))
+			kref_get(&lu->tgt->kref);
+		kref_put(&lu->tgt->kref, sbp2_release_target);
 		return;
 	}
 
Signature · 3 lines
Stefan Richter
-=====-=-=== =-== --===
http://arcgraph.de/sr/
#11 lore raw

PATCH 2/2 firewire: fw-sbp2: refactor workq and kref handling

This somewhat reduces the size of firewire-sbp2.ko.

---
 drivers/firewire/fw-sbp2.c |   56 +++++++++++++++++++------------------
 1 file changed, 30 insertions(+), 26 deletions(-)
drivers/firewire/fw-sbp2.c +30 -26
Index: linux/drivers/firewire/fw-sbp2.c
===================================================================
@@ -628,6 +628,21 @@ static void sbp2_release_target(struct k
 
 static struct workqueue_struct *sbp2_wq;
 
+/*
+ * Always get the target's kref when scheduling work on one its units.
+ * Each workqueue job is responsible to call sbp2_target_put() upon return.
+ */
+static void sbp2_queue_work(struct sbp2_logical_unit *lu, unsigned long delay)
+{
+	if (queue_delayed_work(sbp2_wq, &lu->work, delay))
+		kref_get(&lu->tgt->kref);
+}
+
+static void sbp2_target_put(struct sbp2_target *tgt)
+{
+	kref_put(&tgt->kref, sbp2_release_target);
+}
+
 static void sbp2_reconnect(struct work_struct *work);
 
 static void sbp2_login(struct work_struct *work)
@@ -649,16 +664,12 @@ static void sbp2_login(struct work_struc
 
 	if (sbp2_send_management_orb(lu, node_id, generation,
 				SBP2_LOGIN_REQUEST, lu->lun, &response) < 0) {
-		if (lu->retries++ < 5) {
-			if (queue_delayed_work(sbp2_wq, &lu->work,
-					       DIV_ROUND_UP(HZ, 5)))
-				kref_get(&lu->tgt->kref);
-		} else {
+		if (lu->retries++ < 5)
+			sbp2_queue_work(lu, DIV_ROUND_UP(HZ, 5));
+		else
 			fw_error("failed to login to %s LUN %04x\n",
 				 unit->device.bus_id, lu->lun);
-		}
-		kref_put(&lu->tgt->kref, sbp2_release_target);
-		return;
+		goto out;
 	}
 
 	lu->generation        = generation;
@@ -700,7 +711,8 @@ static void sbp2_login(struct work_struc
 		lu->sdev = sdev;
 		scsi_device_put(sdev);
 	}
-	kref_put(&lu->tgt->kref, sbp2_release_target);
+ out:
+	sbp2_target_put(lu->tgt);
 }
 
 static int sbp2_add_logical_unit(struct sbp2_target *tgt, int lun_entry)
@@ -865,18 +877,13 @@ static int sbp2_probe(struct device *dev
 
 	get_device(&unit->device);
 
-	/*
-	 * We schedule work to do the login so we can easily
-	 * reschedule retries. Always get the ref before scheduling
-	 * work.
-	 */
+	/* Do the login in a workqueue so we can easily reschedule retries. */
 	list_for_each_entry(lu, &tgt->lu_list, link)
-		if (queue_delayed_work(sbp2_wq, &lu->work, 0))
-			kref_get(&tgt->kref);
+		sbp2_queue_work(lu, 0);
 	return 0;
 
  fail_tgt_put:
-	kref_put(&tgt->kref, sbp2_release_target);
+	sbp2_target_put(tgt);
 	return -ENOMEM;
 
  fail_shost_put:
@@ -889,7 +896,7 @@ static int sbp2_remove(struct device *de
 	struct fw_unit *unit = fw_unit(dev);
 	struct sbp2_target *tgt = unit->device.driver_data;
 
-	kref_put(&tgt->kref, sbp2_release_target);
+	sbp2_target_put(tgt);
 	return 0;
 }
 
@@ -915,10 +922,8 @@ static void sbp2_reconnect(struct work_s
 			lu->retries = 0;
 			PREPARE_DELAYED_WORK(&lu->work, sbp2_login);
 		}
-		if (queue_delayed_work(sbp2_wq, &lu->work, DIV_ROUND_UP(HZ, 5)))
-			kref_get(&lu->tgt->kref);
-		kref_put(&lu->tgt->kref, sbp2_release_target);
-		return;
+		sbp2_queue_work(lu, DIV_ROUND_UP(HZ, 5));
+		goto out;
 	}
 
 	lu->generation        = generation;
@@ -930,8 +935,8 @@ static void sbp2_reconnect(struct work_s
 
 	sbp2_agent_reset(lu);
 	sbp2_cancel_orbs(lu);
-
-	kref_put(&lu->tgt->kref, sbp2_release_target);
+ out:
+	sbp2_target_put(lu->tgt);
 }
 
 static void sbp2_update(struct fw_unit *unit)
@@ -947,8 +952,7 @@ static void sbp2_update(struct fw_unit *
 	 */
 	list_for_each_entry(lu, &tgt->lu_list, link) {
 		lu->retries = 0;
-		if (queue_delayed_work(sbp2_wq, &lu->work, 0))
-			kref_get(&tgt->kref);
+		sbp2_queue_work(lu, 0);
 	}
 }
 
Signature · 3 lines
Stefan Richter
-=====-=-=== =-== --===
http://arcgraph.de/sr/