Skip to contentSkip to conversation

eepro100/usb interrupts stop with 2.4.x kernels?

DISCUSSION Michael Poole 3 participants 4 messages May 11, 2001 – May 12, 2001

lore
Share & tools
lore
#0 lore raw

Since about 2.4.2, I have been seeing intermittent hangs on my system; usually once or twice a week, but once just 10 minutes after rebooting.

What seems to happen is that the kernel stops seeing interrupts on the IRQ shared by eth0 (my outside interface) and usb-uhci. I can still ssh in on eth1, and when I do, syslog contains things like "eth0:
Interrupt timed out" and usb-uhci griping about devices that failed to accept new endpoints.

I'm not sure if for some reason my chipset stopped passing these interrupts on to the kernel, or if the kernel got into some funny state and stopped accepting those interrupts. Any hints on where I should look?

Quoted 1 line

From /proc/interrupts now:

CPU0 CPU1

  0:     243741     233914    IO-APIC-edge  timer
  1:          4          0    IO-APIC-edge  keyboard
  2:          0          0          XT-PIC  cascade
  8:          0          0    IO-APIC-edge  rtc
 10:          0          0   IO-APIC-level  EMU10K1
 11:      18775      17937   IO-APIC-level  usb-uhci, eth0
 12:       1221       1236   IO-APIC-level  eth1
 14:      84039      68162    IO-APIC-edge  ide0
 15:         18         18   IO-APIC-level  BusLogic BT-950
NMI:          0          0 
LOC:     477548     477547 
ERR:          0

-- Michael

#1 lore raw
Quoted 5 lines

What seems to happen is that the kernel stops seeing interrupts on the IRQ shared by eth0 (my outside interface) and usb-uhci. I can still ssh in on eth1, and when I do, syslog contains things like "eth0:
Interrupt timed out" and usb-uhci griping about devices that failed to accept new endpoints.

Do you see this if you run a -ac kernel or apply the APIC 440BX patch ?

#2 lore raw
Quoted 7 lines · Alan Cox
Quoted 5 lines

What seems to happen is that the kernel stops seeing interrupts on the IRQ shared by eth0 (my outside interface) and usb-uhci. I can still ssh in on eth1, and when I do, syslog contains things like "eth0:
Interrupt timed out" and usb-uhci griping about devices that failed to accept new endpoints.

Do you see this if you run a -ac kernel or apply the APIC 440BX patch ?

I haven't tried either, but I'm about to reboot into 2.4.4-ac4 to see if it helps. If it still happens, I'll get more of the syslog output and try to figure out what got wedged.

-- Michael

#3 lore raw
In reply to Alan Cox
Quoted 2 lines · Alan Cox

Do you see this if you run a -ac kernel or apply the APIC 440BX patch ?

Alan, what APIC 440BX patch are you referring to? I must have missed it, and I can't find anything in the archives.

Kevin <[email protected]>