Skip to contentSkip to conversation

2.6.14.4 ide-tape not noticing filemarks

DISCUSSION Richard Kettlewell 1 participant 1 message Dec 19, 2005

lore
Share & tools
lore
#0 lore raw

I have a Seagate/Certance ATAPI tape drive, reported thus:

ide-tape: hdd <-> ht0: Seagate STT20000A rev 8A51
ide-tape: hdd <-> ht0: 1000KBps, 6*54kB buffer, 9720kB pipeline, 110ms tDSC, DMA

I've been using this with ide-scsi in Linux 2.4.31 for my backups. It worked OK.

I upgraded to 2.6.14.4 and it seem to have lost the ability to detect filemarks. This happens whether I use it via ide-scsi or use the ide-tape interface directly.

sfere# mt -f /dev/nht0 rewind
sfere# dd if=foo of=/dev/nht0 bs=512 count=1
1+0 records in
1+0 records out
512 bytes transferred in 28.162633 seconds (18 bytes/sec) sfere# dd if=foo of=/dev/nht0 bs=512 count=1
1+0 records in
1+0 records out
512 bytes transferred in 5.520161 seconds (93 bytes/sec) sfere# mt -f /dev/nht0 rewind
sfere# dd if=/dev/nht0 of=bar bs=512 count=2
2+0 records in
2+0 records out
1024 bytes transferred in 6.392595 seconds (160 bytes/sec) sfere# mt -f /dev/nht0 status
drive type = Generic SCSI-2 tape
drive status = 512
sense key error = 0
residue count = 0
file number = 0
block number = 4
Tape block size 512 bytes. Density code 0x0 (default). Soft error count since last status=0
General status bits on (0):

Am I doing something wrong somewhere, or has ide-tape stopped noticing filemarks reliably/at all?

(I see the same problem on tapes written under 2.4.31 but read under 2.6.14.4, which is why I think it's a problem with reading and not writing.)

ttfn/rjk