Skip to content

Preparations for ASIC3 support in the TMIO MMC driver

Philipp Zabel lkml 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 6 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 6 patches the cover letter announces are in this archive.

Reviews trailers per patch

PatchIan Molton
SeriesA-b A-b A-b A-b

Trailers given in replies are filled; those carried in the patches from earlier versions are outlined with dashes.

Read the v1 thread

Cover letter [PATCH 0/6] Preparations for ASIC3 support in the TMIO MMC driver

Hi,

this series is really only two parts preparation for ASIC3:
[PATCH 1/5] MFD,mmc: tmio_mmc: make HCLK configurable
[PATCH 2/5] mmc: tmio_mmc: add bus_shift support
and three parts cleanup:
[PATCH 3/5] mmc: tmio_mmc: don't use set_irq_type
[PATCH 4/5] mmc: tmio_mmc: correct probe return value for num_resources != 3 [PATCH 5/5] mmc: tmio_mmc: move probe function into __init section

I have still a few remaining differences until tmio_mmc can support ASIC3, but as patch 2/5 causes changes all over the place, I'd like to get feedback on that before piling patches on top of it.

I also have a question about the clock divider settings. Currently, tmio_mmc_set_clock returns the wrong divider setting for new_clock=f_min (0x40 instead of 0x80). I tried to fix it like below:

+#define TMIO_CARD_CLOCK_ENABLE 0x0100
+#define TMIO_CARD_CLOCK_FOR_SD 0x8000
+
-static void tmio_mmc_set_clock(struct tmio_mmc_host *host, int new_clock) +static void tmio_mmc_set_clock(struct tmio_mmc_host *host, int new_clock)

 {
        u32 clk = 0, clock;
 
        if (new_clock) {
                for (clock = host->mmc->f_min, clk = 0x100; new_clock >= (clock<<1); ) {
                        clock <<= 1;
                        clk >>= 1;
                }
-               if (clk & 0x1)
-                       clk = 0x20000;
+               /* For fastest speed we disable the divider. */
+               sd_config_write8(host, CNF_SD_CLK_MODE, (clk == 0) ? 0 : 1);
+               clk >>= 1;
-               clk >>= 2;
-               sd_config_write8(host, CNF_SD_CLK_MODE, (clk & 0x8000) ? 0 : 1);
-               clk |= 0x100;
+               clk |= host->clock_for_sd | TMIO_CARD_CLOCK_ENABLE;
        }
 
        sd_ctrl_write16(host, CTL_SD_CARD_CLK_CTL, clk);

But the ASIC3 code was handling the 0x8000 bit (called FOR_SD in the ASIC3 headers) of CTL_SD_CARD_CLK_CTL differently - there it was enabled/disabled based on 1-bit or 4-bit MMC mode. I have no idea what it is good for - is there any TMIO documentation available that includes this information?

regards
Philipp