Skip to content

ARM: MXC: mxc_nand: support i.MX21

Artem Bityutskiy linux-arm-kernel linux-mtd 1 version New

Get series with b4
b4 am 1272353376.26036.2.camel@localhost

Versions newest first

  1. v3 Latest0 of 2 patches 0 repliesNew

Patches in v3 No applies recorded yet

None of the 2 patches the cover letter announces are in this archive.

Reviews trailers per patch

PatchSascha Hauer
SeriesA-b

Trailers given in replies are filled; those carried in the patches from earlier versions are outlined with dashes.

Read the v3 thread

Cover letter [PATCH v3 0/2] ARM: MXC: mxc_nand: support i.MX21
Quoted 13 lines · Ivo Clarysse

Allow mxc_nand.c to function on i.MX21 SoCs, since:

1) On i.MX21, if the NFC_INT_MASK bit in NFC_CONFIG1 is set, the NFC_INT bit of NFC_CONFIG2 always reads out zero, even if an operation is completed.

2) On i.MX21, sending a RESET command to the NAND flash controller does not trigger an interrupt, nor does it cause the NFC_INT bit of NFC_CONFIG2 to get set.

3) After reset is performed, NFC registers are again in their default values.

Quoted 6 lines

This patch series:

- (Re-)sets all NFC registers after reset

- Uses enable_irq / disable_irq_nosync instead of NFC_INT_MASK to mask NFC interrupts (allowing NFC_CONFIG2:NFC_INT to used on i.MX21)

Pushed both patches to l2-mtd-2.6.git / dunno with

See
http://git.infradead.org/users/dedekind/l2-mtd-2.6.git/shortlog/refs/heads/dunno

Signature · 2 lines
Best Regards,
Artem Bityutskiy (????? ????????)