mxc nand: Add support for i.MX5
Get series with b4
b4 am 1357606199.1113.16@snotraVersions newest first
- v1 Latest0 of 13 patches 0 repliesNew
Patches in v1 No applies recorded yet
None of the 13 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [U-Boot] [PATCH 00/13] mxc nand: Add support for i.MX5
Quoted 21 lines · Marek Vasut
Dear Beno?t Th?baudeau,
Quoted 19 lines
Dear Marek Vasut,
Quoted 15 lines · Marek Vasut
Dear Beno?t Th?baudeau,
Quoted 9 lines
Hi all,
This series aims at adding support for i.MX5 to the mxc nand mtd and spl
drivers. It also fixes several issues and cleans up the code a little bit.Best regards,
Beno?tDid this patchset advance any further? Any chance we can see this applied?
Anything I can help with to make it applied?
Quoted 7 lines
Quoted 1 line
Only 13/13 has not yet been applied. I still have to add NFC
support to one
Quoted 1 line
i.MX5 board for the patch to be accepted. Fabio has confirmed that
mx53ard
Quoted 1 line
would be fine.
Sigh ... I have board with NAND pending, so Scott, please apply.
Can you repost it as part of a patchset with that board, and I'll ack so they can go together?
Does this board do NAND boot? If so, new-SPL rather than nand_spl would be nice. Tom's comment at the time was, "I'm OK with pulling this in while providing an on-the-record prod to please find some time to do a conversion or two in time for v2013.01." If this patch is applied now, it would be for the release after v2013.01...
-Scott