Skip to content

RM9200 DT i2c bindings and MPA 1600 support

Joachim Eastwood linux-arm-kernel 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest3 patches 0 repliesNew

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/3ARM: at91: add TWI bindings to RM9200 DTarch/arm/boot/dts/at91rm9200.dtsi arch/arm/mach-at91/at91rm9200.c+21 -00 replies
2/3ARM: at91: add pinctrl nodes to i2c-gpio on RM92000 DTarch/arm/boot/dts/at91rm9200.dtsi+8 -00 replies
3/3ARM: at91: add MPA 1600 DT boardarch/arm/boot/dts/Makefile arch/arm/boot/dts/mpa1600.dts+72 -01 reply
3/3ARM: at91: add MPA 1600 DT board+0 -02 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/3] RM9200 DT i2c bindings and MPA 1600 support

Hi,

1st patch adds bindings for hardware i2c on RM9200. This also includes pinctrl setup.

2nd patch adds pinctrl nodes to i2c-gpio which is need since the gpio pins must be set to open drain. I suspect that this should be done in other AT91 dtsi files as well, unless we want to rely on the bootloader doing it.

3rd patch adds a new RM9200 DT board. This is minimal DT file with a lot of stuff missing. The plan is to add the ASoC stuff next.

Joachim Eastwood (3):
ARM: at91: add TWI bindings to RM9200 DT
ARM: at91: add pinctrl nodes to i2c-gpio on RM92000 DT
ARM: at91: add MPA 1600 DT board

 arch/arm/boot/dts/Makefile        |  1 +
 arch/arm/boot/dts/at91rm9200.dtsi | 28 +++++++++++++++
 arch/arm/boot/dts/mpa1600.dts     | 71 +++++++++++++++++++++++++++++++++++++++
 arch/arm/mach-at91/at91rm9200.c   |  1 +
 4 files changed, 101 insertions(+)
 create mode 100644 arch/arm/boot/dts/mpa1600.dts
Signature · 1 line
1.8.0