Skip to content

Tegra: MMC: Add DT support for MMC to T20 boards

Lucas Stach u-boot 1 version New

Get series with b4
b4 am 1360886803.1702.8.camel@localhost

Versions newest first

  1. v4 Latest0 of 4 patches 0 repliesNew

Patches in v4 No applies recorded yet

None of the 4 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v4 yet.

Read the v4 thread

Cover letter [U-Boot] [PATCH v4 0/4] Tegra: MMC: Add DT support for MMC to T20 boards

Am Donnerstag, den 14.02.2013, 14:03 -0700 schrieb Tom Warren:

Quoted 15 lines

This patchset adds device-tree support to the Tegra MMC driver. All device config is done via properties in the DT files instead of hard-coded config options/function arguments.

I've tested this on my Seaboard and everything works fine, including card detect. For the other T20 boards, I've used the Linux kernel DTS files for the sdhci nodes where there wasn't one already, or expanded the info that was already there. Everything builds fine, but I haven't tested anything but Seaboard.

v2: Changes as per Stephen's & Simon's review
v3: Changes as per Stephen/Lucas/Thierry/Simon's feedback
v4: Additional changes as per Stephen/Lucas/Thierry/Simon

Quoted 6 lines

Tom Warren (4):
fdt: Add dts/dtsi file include paths to DTC command line
Tegra: fdt: Add/enhance sdhci (mmc) nodes for all T20 DT files
Tegra: fdt: tamonten: Add common tamonten.dtsi file from linux
Tegra: MMC: Add DT support to MMC driver for all T20 boards

When applying, patches 2 and 3 should be swapped around to avoid intermediate breakage in the series.

Regards,
Lucas