Skip to content

ARCH: shmobile: defconfig consolidation

Laurent Pinchart linux-arm-kernel linux-sh 1 version New

Get series with b4
b4 am 1374328.KVLKlOlad0@avalon

Versions newest first

  1. v1 Latest0 of 7 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 7 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [RFC/PATCH 0/7] ARCH: shmobile: defconfig consolidation

Hi Simon,

Quoted 8 lines · On Thursday 04 April 2013 12:29:46 Simon Horman wrote:

Hi,

this is a first pass at consolidating the defconfigs of shmobile.

It covers the mackerel, amradillo800eva and kzm9d boards which meet the following criteria:

* Have the same base memory address (0x40000000).

Do you know if there's any work being done on getting rid of the base memory address as a kernel config option ? It seriously hinders cross-SoC kernel testing.

Quoted 41 lines

* Work with RUNTIME_PM, it is desirable to have that a common defconfig
* Are booted via DT, enabling the command line to be supplied in the dts. This is important to allow serial console and early printk settings, which vary wildly between boards, to be supplied.
* Boards I have to test.
This didn't eliminate any candidates that met the above criteria.

I believe it should also be possible to add support for the APE6EVM board to the consolidated defconfig once problems with RUNTIME_PM have been isolated and resolved. I have send an email about this in a separate thread "APE6EVM and Runtime PM".

I believe it may be possible to add support for the lager board to the consolidated defconfig once I am able to bring that board up, which should be rather soon. The lager board does not currently have a defconfig.

Morimoto-san, I suspect it may be possible to add support for the bockw board to the consolidated defconfig if its boot loader supports booting using a zImage. In this case even though the base memory address is not the same as the boards above it should be possible to specify the base address from the boot loader. As I do not have a bockw board I am wondering if you could investigate this.

Simon Horman (7):
ARM: shmobile: prune defconfig
ARM: shmobile: make defconfig canonical
ARM: shmobile: Add kzm9d to consolidated defconfig
ARM: shmobile: Add mackerel to consolidated defconfig
ARM: shmobile: defconfig: Remove armadillo800eva defconfig
ARM: shmobile: defconfig: Remove kzm9d defconfig
ARM: shmobile: defconfig: Remove mackerel defconfig

 arch/arm/configs/armadillo800eva_defconfig |  153 -------------------------
 arch/arm/configs/kzm9d_defconfig           |   88 ----------------
 arch/arm/configs/mackerel_defconfig        |  156 -------------------------
 arch/arm/configs/shmobile_defconfig        |   51 +++++----
 4 files changed, 28 insertions(+), 420 deletions(-)
 delete mode 100644 arch/arm/configs/armadillo800eva_defconfig
 delete mode 100644 arch/arm/configs/kzm9d_defconfig
 delete mode 100644 arch/arm/configs/mackerel_defconfig
Signature · 3 lines
Regards,

Laurent Pinchart