Skip to content

Add bootcount support to SPL

Tom Rini u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest2 patches 0 repliesNew

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/2SPL: Add CONFIG_SPL_BOOTCOUNT_SUPPORTREADME common/spl/spl.c doc/README.falcon +2 more+42 -11 reply
1/2SPL: Add CONFIG_SPL_BOOTCOUNT_SUPPORT+0 -00 replies
2/2am335x: Switch to CONFIG_SPL_BOOTCOUNT_SUPPORTboard/ti/am335x/board.c include/configs/ti_am335x_common.h+5 -10 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [PATCH 0/2] Add bootcount support to SPL

The following patches depend on the series I posted earlier that adds environment support to SPL as well as the series that converts the davinci bootcount driver to support am335x as well. The most obvious issue to me as that as Scott pointed out with the last series, this would be clearer Kconfig where we wouldn't need to introduce CONFIG_SPL_BOOTCOUNT_SUPPORT and just re-use CONFIG_BOOTCOUNT_SUPPORT. Other than that, I think things look good. It may be possible to re-jigger bootcount drivers to allow counting for both SPL and full U-Boot to happen, if that's strongly desired but the way I see this being used is to fall-back to a failsafe full U-Boot to do what's needed there.

Signature · 1 line
Tom