Create separate header for ehci-dbgp driver

The FUSBH200 and FOTG210 are not EHCI-compatible and require standalone drivers. See discussion at:

http://comments.gmane.org/gmane.linux.usb.general/84169

But these controllers do implement an EHCI-compatible debug port and therefore leverage the ehci-dbgp driver. Rather than pulling in the necessary declarations from <linux/usb/ehci_def.h>, each driver copies this code into their own header. The goal of this series is to pull the ehci-dbgp related code into its own header to remove the need for this redundancy.

Regards,

Chris Rorvick

Chris Rorvick (10):
usb: Create separate header for ehci-dbgp
fusbh200: Make Xen notification consistent with EHCI
fusbh200: Remove superfluous macro definitions
fusbh200: Remove duplicate ehci-dbgp declarations
fusbh200: Use ehci_dbg_port struct
fotg210: Make Xen notification consistent with EHCI
fotg210: Remove superfluous macro definitions
fotg210: Remove duplicate ehci-dbgp declarations
fotg210: Use ehci_dbg_port struct
usb: Remove __init from early_dbgp_init() prototype

 drivers/usb/host/fotg210.h    | 62 ++------------------------------
 drivers/usb/host/fusbh200.h   | 62 ++------------------------------
 include/linux/usb/ehci-dbgp.h | 83 +++++++++++++++++++++++++++++++++++++++++++
 include/linux/usb/ehci_def.h  | 65 ++-------------------------------
 4 files changed, 91 insertions(+), 181 deletions(-)
 create mode 100644 include/linux/usb/ehci-dbgp.h

1.9.3