Skip to content

Jetson-TK1 support for PSCI

Ian Campbell u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 4 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 4 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [PATCH v1 0/4] Jetson-TK1 support for PSCI
Quoted 15 lines · Thierry Reding

We've had some discussions about this internally and I think this should not be a problem after all. The Tegra flow controller can be programmed to automatically coordinate with the PMC to powergate CPUs when they encounter a WFI instruction and unpowergate CPUs again when they are woken up. With that in place the PMC registers don't need to be touched anymore once the CPUs have been booted once.

The solution that was discussed internally would involve having the secure monitor (U-Boot's PSCI implementation in this case) program the flow controller appropriately, point the CPU reset vectors to a location containing a WFI instruction and power up the CPUs. That way they should immediately be powergated when they reach the WFI instruction and the PSCI implementation would then be able to wake them up without accessing the PMC registers once the kernel has booted.

Quoted 5 lines

Adding Peter. Please correct me if I misunderstood what we discussed. Can you also provide Ian with pointers to the registers that need to be programmed to make this work? I suspect that a lot of it can be gleaned from the cpuidle drivers in arch/arm/mach-tegra in the upstream Linux kernel.

Thanks, any *info would be good even though I could likely decode it from the driver...

I'm afraid I've been a bit slack about updating the series with the other comments, mostly because I've been procrastinating over this powergate issue.

Ian.