Skip to content

RFC Generating kwb image for custom board

Chris Packham u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 RFC Latest0 of 1 patch 0 repliesNew

Patches in v1 No applies recorded yet

The patch the cover letter announces is not in this archive.

Reviews trailers per patch

PatchStefan Roese
SeriesA-b

Trailers given in replies are filled; those carried in the patches from earlier versions are outlined with dashes.

Read the v1 thread

Cover letter [U-Boot] [RFC PATCH v1 0/1] Generating kwb image for custom board

Hi,

I'm trying to get u-boot 2015.01 up and running on a custom board using an integrated version of Marvell's Armada-XP in a switch ASIC (the Marvell term is MSYS).

One thing I ran into after extracting the DDR initialisation from the Marvell bootloader was that the Bootrom Firmware (Marvell's pre-bootloader) reported the following

BootROM 1.34
Booting from SPI flash
BootROM: Bad header at offset 00000000
BootROM: Bad header at offset 00200000
...

After a bit of debugging I found that this was because the binary.0 for my board had a length of 0x0148ec which doesn't conform to the following requirement in the Marvell functional spec -- "The header length in bytes. The value must be aligned to 4B." While I could pad out my binary.0 it seems safer to update kwbimage.c to conform with the specification.

The original issue still exists in master but I suspect now that master is using a u-boot-spl image for the Armada-XP boards the spl image is implicitly conformant.

Chris Packham (1):
kwbimage: Align v1 binary header to 4B

 tools/kwbimage.c | 1 +
 1 file changed, 1 insertion(+)
Signature · 1 line
2.2.0.rc0