Skip to content

MIPS: call debug_uart_init right before board_init_f

Álvaro Fernández Rojas u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 4 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 4 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [PATCH 0/4] MIPS: call debug_uart_init right before board_init_f

All MIPS boards that support debug uart are calling debug_uart_init right at the beginning of board_early_init_f.
Instead of doing that, let's provide a generic call to debug_uart_init right before the call to board_init_f if debug uart is enabled.

v2: Introduce the changes suggested by Daniel Schwierzeck:
- Call debug_uart_init before low level init for boards with stack in SRAM.

Daniel Schwierzeck (1):
MIPS: call debug_uart_init right before board_init_f

Álvaro Fernández Rojas (3):
MIPS: QCA AP121: remove debug_uart_init call
MIPS: QCA AP143: remove debug_uart_init call
MIPS: tl-wdr4300: remove debug_uart_init call

 arch/mips/cpu/start.S          | 14 ++++++++++++++
 board/qca/ap121/ap121.c        |  3 ---
 board/qca/ap143/ap143.c        |  3 ---
 board/tplink/wdr4300/wdr4300.c | 18 ++++++++++++++----
 4 files changed, 28 insertions(+), 10 deletions(-)
Signature · 1 line
2.1.4

Read the cover letter in its thread