Skip to content

Add basic node support for Mediatek MT8183 SoC

Erin Lo linux-arm-kernel linux-devicetree linux-mediatek linux-serial lkml 3 versions – In review

Get series with b4
b4 am [email protected]

Versions newest first · linked by author and title

  1. v11 Latest6 patches 1 replyIn review
  2. v101 patch 0 repliesSuperseded
  3. v91 patch 3 repliesSuperseded

Changes in v11 from the cover letter

New add spi node, efuse node, pinctrl node, auxadc node, and capacity-dmips-mhz field

Patches in v11 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/6arm64: dts: Add Mediatek SoC MT8183 and evaluation board dts and Makefilearch/arm64/boot/dts/mediatek/Makefile arch/arm64/boot/dts/mediatek/mt8183-evb.dts arch/arm64/boot/dts/mediatek/mt8183.dtsi+343 -00 replies
2/6arm64: dts: mt8183: add capacity-dmips-mhzarch/arm64/boot/dts/mediatek/mt8183.dtsi+8 -00 replies
3/6arm64: dts: mt8183: add pinctrl device nodearch/arm64/boot/dts/mediatek/mt8183.dtsi+25 -00 replies
4/6arm64: dts: mt8183: Add auxadc device nodearch/arm64/boot/dts/mediatek/mt8183-evb.dts arch/arm64/boot/dts/mediatek/mt8183.dtsi+14 -00 replies
5/6arm64: dts: mt8183: add spi nodearch/arm64/boot/dts/mediatek/mt8183-evb.dts arch/arm64/boot/dts/mediatek/mt8183.dtsi+183 -00 replies
6/6arm64: dts: mt8183: add efuse and Mediatek Chip id node to readarch/arm64/boot/dts/mediatek/mt8183.dtsi+15 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v11 yet.

Read the v11 thread

Cover letter [PATCH v11 0/6] Add basic node support for Mediatek MT8183 SoC

MT8183 is a SoC based on 64bit ARMv8 architecture.
It contains 4 CA53 and 4 CA73 cores.
MT8183 share many HW IP with MT65xx series.
This patchset was tested on MT8183 evaluation board and use correct clock to shell.

Based on v5.2-rc1

Change in v11:
New add spi node, efuse node, pinctrl node, auxadc node, and capacity-dmips-mhz field

Change in v10:
Add the L2 cache node to prevent warning on unable to detect cache hierarchy.

Change in v9:
Remove pio node since binding is not documented yet

Change in v8:
1. Fix interrupt-parent of pio node
2. Remove pinfunc.h and spi node patches

Change in v7:
1. Place all the MMIO peripherals under one or more simple-bus nodes
2. Make the pinfunc.h and spi node into seperate patch
3. Modify SPIs pamerater from 4 back to 3
and remove patch "support 4 interrupt parameters for sysirq"
4. Rename intpol-controller to interrupt-controller
5. Rename pinctrl@1000b000 to pinctrl@10005000

Change in v6:
1. Remove power and iommu nodes
2. Fix dtb build warning
3. Fix pinctrl binding doc
4. Fix '_' in node names

Change in v5:
1. Collect all device tree nodes to the last patch
2. Add PMU
3. Add Signed-off-by
4. Remove clock driver code and binding doc
5. Add pinctrl, iommu, spi, and pwrap nodes

Change in v4:
1. Correct syntax error in dtsi
2. Add MT8183 clock support

Change in v3:
1. Fill out GICC, GICH, GICV regions
2. Update Copyright to 2018

Change in v2:
1. Split dt-bindings into different patches
2. Correct bindings for supported SoCs (mtk-uart.txt)

Ben Ho (1):
arm64: dts: Add Mediatek SoC MT8183 and evaluation board dts and
Makefile

Erin Lo (1):
arm64: dts: mt8183: add spi node

Hsin-Yi, Wang (1):
arm64: dts: mt8183: add capacity-dmips-mhz

Michael Mei (1):
arm64: dts: mt8183: add efuse and Mediatek Chip id node to read

Zhiyong Tao (2):
arm64: dts: mt8183: add pinctrl device node
arm64: dts: mt8183: Add auxadc device node

 arch/arm64/boot/dts/mediatek/Makefile       |   1 +
 arch/arm64/boot/dts/mediatek/mt8183-evb.dts | 140 ++++++
 arch/arm64/boot/dts/mediatek/mt8183.dtsi    | 447 ++++++++++++++++++++
 3 files changed, 588 insertions(+)
 create mode 100644 arch/arm64/boot/dts/mediatek/mt8183-evb.dts
 create mode 100644 arch/arm64/boot/dts/mediatek/mt8183.dtsi

--
1.8.1.1.dirty