Skip to content

scsi: ufs: Add a vops to configure VCC voltage level

Nitin Rawat linux-scsi lkml 2 versions – In review

Get series with b4
b4 am [email protected]

Versions newest first · linked by author and title

  1. v2 Latest3 patches 10 repliesIn review
  2. v13 patches 5 repliesSuperseded

Changes in v2 from the cover letter

Added suggested-by on patch2 (scsi: ufs: add a vops to configure VCC voltage level)

Patches in v2 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/3scsi: ufs: export api for use in vendor filedrivers/scsi/ufs/ufshcd.c drivers/scsi/ufs/ufshcd.h+10 -30 replies
2/3scsi: ufs: add a vops to configure VCC voltage leveldrivers/scsi/ufs/ufshcd.c drivers/scsi/ufs/ufshcd.h+14 -03 replies
3/3scsi: ufs-qcom: configure VCC voltage level in vendor filedrivers/scsi/ufs/ufs-qcom.c+51 -07 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v2 yet.

Read the v2 thread

Cover letter [PATCH V2 0/3] scsi: ufs: Add a vops to configure VCC voltage level

UFS specification allows different VCC configurations for UFS devices, for example,

	(1)2.70V - 3.60V (For UFS 2.x devices)
	(2)2.40V - 2.70V (For UFS 3.x devices)

For platforms supporting both ufs 2.x (2.7v-3.6v) and
ufs 3.x (2.4v-2.7v), the voltage requirements (VCC) is 2.4v-3.6v. So to support this, we need to start the ufs device initialization with the common VCC voltage(2.7v) and after reading the device descriptor we need to switch to the correct range(vcc min and vcc max) of VCC voltage as per UFS device type since 2.7v is the marginal voltage as per specs for both type of devices.

Once VCC regulator supply has been intialised to 2.7v and UFS device type is read from device descriptor, we follows below steps to change the VCC voltage values.

1. Set the device to SLEEP state.
2. Disable the Vcc Regulator.
3. Set the vcc voltage according to the device type and reenable the regulator.
4. Set the device mode back to ACTIVE.

The above changes are done in vendor specific file by adding a vops which will be needed for platform supporting both ufs 2.x and ufs 3.x devices.

v1 -> v2
Added suggested-by on patch2 (scsi: ufs: add a vops to configure VCC voltage level)

Nitin Rawat (3):
scsi: ufs: export api for use in vendor file
scsi: ufs: add a vops to configure VCC voltage level
scsi: ufs-qcom: configure VCC voltage level in vendor file

 drivers/scsi/ufs/ufs-qcom.c | 51 +++++++++++++++++++++++++++++++++++++++++++++
 drivers/scsi/ufs/ufshcd.c   | 13 +++++++++---
 drivers/scsi/ufs/ufshcd.h   | 14 +++++++++++++
 3 files changed, 75 insertions(+), 3 deletions(-)

--
2.7.4