Skip to content

Add support for page scope read

Md Sadre Alam linux-mtd lkml 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest3 patches 10 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/3mtd: rawnand: qcom: Add support for status pipedrivers/mtd/nand/raw/qcom_nandc.c+14 -03 replies
2/3mtd: rawnand: qcom: Add sg list to handle status pipe requestdrivers/mtd/nand/raw/qcom_nandc.c+34 -03 replies
3/3mtd: rawnand: qcom: Add support for page scope readdrivers/mtd/nand/raw/qcom_nandc.c+71 -63 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/3] Add support for page scope read

These series of patches to support page scope read.

In QPIC v1, SW is needed to write EXEC_CMD register for each Code word and collect any Status related to that CW before issueing EXEC_CMD for next CW.

Page scope command, currently supported only for read commands in bam mode, is truly a page mode command where SW is required to issue EXEC_CMD only once for a page. Controller HW takes care of Codeword specific details and automatically returns status associated with each CW to BAM pipe, dedicated for status deposition.

Md Sadre Alam (3):
mtd: rawnand: qcom: Add support for status pipe
mtd: rawnand: qcom: Add sg list to handle status pipe request
mtd: rawnand: qcom: Add support for page scope read

 drivers/mtd/nand/raw/qcom_nandc.c | 125 ++++++++++++++++++++++++++++++++++++--
 1 file changed, 119 insertions(+), 6 deletions(-)
Signature · 1 line
2.7.4