Skip to content

Add rlimit controller to cgroups (v3)

Balbir Singh linux-mm lkml 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest4 patches 27 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/4Setup the rlimit controllerinclude/linux/cgroup_subsys.h include/linux/rlimitcgroup.h init/Kconfig +2 more+175 -04 replies
2/4Enhance cgroup mm_owner_changed callback to add task informationinclude/linux/cgroup.h kernel/cgroup.c+3 -23 replies
3/4Add rlimit controller accounting and controlarch/ia64/kernel/perfmon.c arch/x86/kernel/ds.c fs/exec.c +4 more+149 -111 replies
4/4Add rlimit controller documentationDocumentation/controllers/rlimit.txt+29 -04 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [-mm][PATCH 0/4] Add rlimit controller to cgroups (v3)

This is the third version of the address space control patches. These patches are against 2.6.25-mm1 and have been tested using KVM in SMP mode, both with and without the config enabled.

The first patch adds the user interface. The second patch fixes the cgroup mm_owner_changed callback to pass the task struct, so that accounting can be adjusted on owner changes. The thrid patch adds accounting and control. The fourth patch updates documentation.

An earlier post of the patchset can be found at
http://lwn.net/Articles/275143/

This patch is built on top of the mm owner patches and utilizes that feature to virtually group tasks by mm_struct.

Reviews, Comments?

Series

rlimit-controller-setup.patch
cgroup-add-task-to-mm--owner-callbacks.patch
rlimit-controller-address-space-accounting.patch
rlimit-controller-add-documentation.patch

Signature · 10 lines
	Warm Regards,
	Balbir Singh
	Linux Technology Center
	IBM, ISTL

--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to [email protected].  For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"[email protected]"> [email protected] </a>