Skip to content

i.MX31: Add NAND support and new PDK board.

Jean-Christophe PLAGNIOL-VILLARD u-boot 2 versions – New

Get series with b4
b4 am [email protected]

Versions newest first · linked by author and title

  1. v3 Latest6 patches 0 repliesNew
  2. v24 of 6 patches 0 repliesSuperseded

Patches in v3 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/6i.MX31: Add reset_timer() and modify get_timer_masked().+0 -00 replies
2/6i.MX31: Make the SPI bus and chip select configurable for MC13783+0 -01 reply
2/6i.MX31: Make the SPI bus and chip select configurable for MC13783+0 -01 reply
3/6i.MX31: Add basic support for Freescale's i.MX31 PDK board.+0 -01 reply
3/6i.MX31: Add basic support for Freescale's i.MX31 PDK board.+0 -02 replies
3/6i.MX31: Add basic support for Freescale's i.MX31 PDK board.+0 -00 replies
3/6i.MX31: Add basic support for Freescale's i.MX31 PDK board.+0 -01 reply
3/6i.MX31: Add basic support for Freescale's i.MX31 PDK board.+0 -01 reply

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v3 yet.

Read the v3 thread

Cover letter [U-Boot] [PATCH v3 0/6] i.MX31: Add NAND support and new PDK board.
Quoted 20 lines · Magnus Lilja

Hi,

2008/8/29 Magnus Lilja <[email protected]>:

Quoted 17 lines

Hi again

This series of patches adds support for the NAND flash controller in the i.MX31 device and also introduces the Freescale i.MX31 PDK board.

Changes since v2:

- Added doc/README.mx31 (contains MC13783 SPI config documentation)
- Split the PDK patch into two patches, the first introduces the board without NAND support, the second adds NAND support.
- Re-ordered the series so the NAND patches are placed last
- mx31_nand.c has been updated w.r.t. coding style.
- There are still issues with the NAND driver (i.e. not all comments from Scott Wood have been taken care of yet). Therefore I suspect that the NAND driver is not ready for inclusion yet, the other patches should be OK.

Quoted 8 lines
Quoted 2 lines

The patches are based on the current main U-boot git repo (as of Friday morning).

Is there are chance that the first couple of patches in the series can be merged into the official tree? I'm talking about the following patches:
[PATCH v3 1/6] i.MX31: Add reset_timer() and modify get_timer_masked().

yes

Quoted 1 line

[PATCH v3 2/6] i.MX31: Make the SPI bus and chip select configurable for MC13783

yes

Quoted 1 line

[PATCH v3 3/6] i.MX31: Add basic support for Freescale's i.MX31 PDK board.

It will be apply in arm test branch until it can boot with flash

Best Regards,
J.