Skip to content

RFC Freescale "eSDHC" SDHCI support (was [PATCH] mmc: Add driver for Freescale eSDHC controllers)

Anton Vorontsov linuxppc-dev lkml 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 RFC Latest10 patches 6 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/10sdhci: Add quirk for controllers with no end-of-busy IRQdrivers/mmc/host/sdhci.c drivers/mmc/host/sdhci.h+6 -10 replies
2/10sdhci: Add support for bus-specific IO memory accessorsdrivers/mmc/host/sdhci.c drivers/mmc/host/sdhci.h+177 -812 replies
3/10sdhci: Add support for card-detection pollingdrivers/mmc/host/sdhci.c drivers/mmc/host/sdhci.h+8 -00 replies
4/10sdhci: Add support for hosts reporting inverted write-protect statedrivers/mmc/host/sdhci.c drivers/mmc/host/sdhci.h+4 -00 replies
5/10sdhci: Add support for hosts with strict 32 bit addressingdrivers/mmc/host/sdhci.c drivers/mmc/host/sdhci.h+17 -50 replies
6/10sdhci: Add quirk to suppress PIO interrupts during DMA transfersdrivers/mmc/host/sdhci.c drivers/mmc/host/sdhci.h+33 -00 replies
7/10sdhci: Add support for hosts that don't specify clocks in the cap. registerdrivers/mmc/host/sdhci.c+14 -150 replies
8/10sdhci: Add set_clock callbackdrivers/mmc/host/sdhci.c drivers/mmc/host/sdhci.h+7 -00 replies
9/10sdhci: Add quirk for Freescale eSDHC controllersdrivers/mmc/host/sdhci.c drivers/mmc/host/sdhci.h+33 -60 replies
10/10mmc: Add OpenFirmware bindings for SDHCI driverdrivers/mmc/host/Kconfig drivers/mmc/host/Makefile drivers/mmc/host/sdhci-of.c+285 -04 replies

Reviews trailers per patch

1 of 10 patches has a Reviewed-by or Acked-by.

PatchArnd Bergmann
1/10
2/10
3/10
4/10
5/10
6/10
7/10
8/10
9/10
10/10A-b

Trailers given in replies are filled; those carried in the patches from earlier versions are outlined with dashes.

Read the v1 thread

Cover letter [PATCH RFC 0/10] Freescale "eSDHC" SDHCI support (was [PATCH] mmc: Add driver for Freescale eSDHC controllers)
Quoted 9 lines · Liu Dave
Quoted 3 lines

This patch adds support for the Freescale Enhanced Secure Digital Host Controller Interface as found in some Freescale PowerPC microprocessors (e.g. MPC837x SOCs).

The Freescale ESDHC controller is basically compatible with the standard SDHC controller. but the eshdc expand some bits.

The esdhc.c is much like the orignal sdhci.c.
it is possible to merge them.

Seem to work indeed. Quite a lot of quirks needed though.

Patches on the way...

Signature · 3 lines
Anton Vorontsov
email: [email protected]
irc://irc.freenode.net/bd2