Skip to content

ixp/npe: Move conditional compilation to Makefile

Jean-Christophe PLAGNIOL-VILLARD u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 5 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 5 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [PATCH 0/5] ixp/npe: Move conditional compilation to Makefile
Quoted 7 lines · Jean-Christophe PLAGNIOL-VILLARD
Quoted 6 lines · Wolfgang Denk

Dear Jean-Christophe PLAGNIOL-VILLARD,

Quoted 3 lines · In message <[email protected]> you wrote:
Quoted 3 lines

I suggest we remove the code for these broken boards from the U-Boot tree.

Quoted 9 lines
Quoted 6 lines

...

Quoted 3 lines

we can easly fix it by removing the option to embedeed the FW and update the board config to load it from flash until we have a new clean drivers

Then can we do that, please?

The only problem will be the board without Maintainer so I do not known where to place it in the flash

this following two patch will acheive this

Actually only 2 boards will nees to define where they will store it in flash or somewhere else and the load in at default ram address via CONFIG_IXP4XX_NPE_EXT_UCODE_BASE

Stefan Could you take on the 2 that you maintain
ixdpg425, pdnb3

Best Regards,
J.