Skip to content

Make sure 85xx bss doesn't start at 0x0

Wolfgang Denk u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 2 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 2 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [PATCH 0/2] Make sure 85xx bss doesn't start at 0x0

Dear Peter Tyser,

Quoted 3 lines · In message <[email protected]> you wrote:

I understand that the final addresses in RAM of all the sections are calculated by U-Boot during relocation based on memory size. However,

True. And nothing is ever written to the bss addresses as recorded in the linked image as running from flash, may thei be 0x0 0r 0x10 or any other random address.

Quoted 11 lines

the section addresses are the same relative to each other at link time as well as after relocation. Eg before relocation I print out:

(408) &_start = fff80000
(409) &__bss_start = (null)
(410) &_end = 00008184
Now running in RAM - U-Boot at: 7ff70000 (After relocation)
(665) &_start = 7ff70000
(666) &__bss_start = 7fff0000
(667) &_end = 7fff8184

Quoted 6 lines

The values all changed and are dependent on RAM size, but their relationship to one another didn't - they all just increased by 0x7fff0000. So practically speaking, we do need to know where the bss is at link time - its address is not dynamic like the malloc pool or stack - its tied directly to the address of the other sections at link time. (Unless we added some bss-specific fixups I imagine)

Right, that's the current situation.

My suggestion was NOT to put the bss at a fixed _offset_ to the U-Boot image, but to a fixed absolute address. My hope is that this might simplify the linker scripts at the cost of adding a little code to the relocation routine - for addresses in the bss we would have to add a different relocation offset.

Best regards,

Wolfgang Denk

Signature · 5 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Love sometimes expresses itself in sacrifice.
	-- Kirk, "Metamorphosis", stardate 3220.3