Skip to content

RFC Add support for Freescale's 85xx and P1/P2xxx eSPI controller

Wolfgang Denk u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 RFC Latest0 of 4 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 4 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [RFC] [PATCH 0/4] Add support for Freescale's 85xx and P1/P2xxx eSPI controller

Dear Can Aydin,

Quoted 6 lines · In message <[email protected]> you wrote:
Quoted 4 lines

Can the Chip Select Pins be used as GPIO? It might be simpler to do that than
adding a speciality to common code.

True, a GPIO pin could be re-purposed to serve as chip select, but that would involve a soldering iron and a steady hand as the P1/P2xxRDB

That was not the question.

Reinhard asked if the SPI Chip Select Pins could be configured such so that they can be used in GPIO mode instead of special function mode. That would make code way simpler.

Quoted 3 lines

People could also choose to bitbang the SPI on their custom hardware but again I feel that might defeat the purpose and spirit of u-boot. (Then again, I'm new so don't quote me on that).

Oops? Where exactly do you see conflicts with "the purpose and spirit" of U-Boot?

Best regards,

Wolfgang Denk

Signature · 6 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"Where humor is concerned there are no standards -- no  one  can  say
what is good or bad, although you can be sure that everyone will.
- John Kenneth Galbraith