Nokia RX-51 support
Get series with b4
b4 am [email protected]Versions newest first
- v1 Latest1 of 14 patches 0 repliesNew
1 of 14 patches is in this archive. The cover letter announces 14.
Patches in v1 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 11/14 | New config variable CONFIG_PREMONITOR | +0 | 0 replies |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [U-Boot] [PATCH 00/14] Nokia RX-51 support
Quoted 34 lines · On Wednesday 25 January 2012 22:29:16 Marek Vasut wrote:
Quoted 33 lines
Quoted 32 lines · On Wednesday 25 January 2012 21:56:37 Marek Vasut wrote:
Quoted 18 lines
Quoted 9 lines · On Wednesday 25 January 2012 19:20:01 Marek Vasut wrote:
Quoted 1 line
So why not just replace the bootloader right away?
Booting process on n900:
1. Omap bootrom
2. Nokia X-Loader
3. Nokia NOLO Bootloader
4. Linux kernel
...To make it clear, I own N900 myself ;-)
Quoted 6 lines
Nokia X-Loader and NOLO are stored in first nand part. It has size 128kB. Nokia X-Loader is signed (size 14.5kB), so cannot be replaced. NOLO bootloader is not signed (so theoretically can be replaced), but size is limited to 113kB. I do not know how to compile U-Boot binary with size < 113kB...
Quoted 8 lines
Quoted 5 lines
Size of part where is stored linux kernel has 2MB and it is enought for
U-Boot with kernel image (~200kB + ~1.6MB). Also U-Boot can boot kernel
from eMMC/SD.You didn't answer my question, so again ... why can't you replace NOLO? Because there's the 113kb limit? Use SPL then.
I only tried to boot U-Boot in qemu wich increased boot part - but not worked. (NOLO in qemu can boot u-boot without problems). So NOLO do some extra work - which I do not know... Also limit is problem to test on real n900.
Quoted 5 lines
Quoted 2 lines
What do you mean? Did you crack yours open? Can you connect JTAG to the device? I didn't check on mine.
I have no idea if N900 has JTAG. And I think that nobody cracked X-Loader yet.
What do you mean, you don't need xloader, u-boot SPL can replace it.
Quoted 4 lines
NOLO bootloader can be replaced/flashed via flasher-3.5 app throw USB. Also when NOLO is damaged (or cleared/replaced) it can restored - coldflashed again via flasher-3.5.
I know. So ... ? Basically you can use the TI flashes too since it all goes through the bootrom, right?
Quoted 8 lines
What I tried:
I created mtd image where was X-Loader, NOLO and U-Boot. QEmu RX51 successfull booted this image and I got serial console and video screen output.But when I created mtd image where was only X-Loader an U-Boot, QEmu RX51 was unable to boot (it freezed).
Why? Where? You know you can debug U-Boot in QEMU with GDB and diag the problem properly?
Quoted 4 lines
So NOLO executing some code which inilialize board or someting else which must be done in U-Boot board code. There is no documentation or info about NOLO, so I cannot create working NOLO replacement.
Yes you can, either observe it or disas it.
M