Skip to content

add EDO feature for gpmi-nand driver

Marek Vasut linux-arm-kernel linux-mtd 2 versions New

Get series with b4
b4 am [email protected]

Versions newest first · linked by author and title

  1. v2 Latest posting 2/20 of 9 patches 0 repliesNew
  2. v2 posting 1/20 of 9 patches 0 repliesSuperseded

Patches in v2 posting 2/2 No applies recorded yet

None of the 9 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v2 yet.

Read the v2 thread

Cover letter [PATCH v2 0/9] add EDO feature for gpmi-nand driver

Dear Huang Shijie,

Quoted 33 lines
Quoted 33 lines

The ONFI nand supports the EDO (extended data out) feature in asynchronous mode when the host controller(such as gpmi-nand) uses a tRC of less then 30ns.

The gpmi can supports this EDO feature.
This patch set adds the EDO support the gpmi-nand driver.

patch 1 ~ patch 2:
These two patches provide the infrastructure for the EDO feature.

They add necessary MTD helpers for the ONFI nand set/get features,

and the help to get the supportted timing mode. These two patches are new version. The init version has been reviewed by Vikram & Florian.

patch 3 ~ patch 7:
These patches are clean-ups for the gpmi-nand's timing code.

Also they make the some preparations for the EDO patch.

patch 8: add the EDO feature to the gpmi-nand.

patch 9: a small optimization for the timing.

only set the timing registers one time.

I tested this patch set on the IMX6Q-arm2 board with several Micron's ONFI nand chips. Some chips only can supports to mode 4, some chips can supports to mode 5.

Quoted 7 lines
Quoted 3 lines

The performance is much improved. Take Micron MT29F32G08MAA for example

(in mode 5, 100MHz):

[...]

Was this ever tested on something else than mx6q? I suspect these broke gpmi nand on mx28. Can you please verify?

Hm, this series isnt the problematic one ... poking further ... I recall next 20120921 worked fine.

Best regards,
Marek Vasut