Skip to content

ARM: Kirkwood: Convert to pinctrl

Andrew Lunn linux-arm-kernel 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 9 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 9 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/9] ARM: Kirkwood: Convert to pinctrl
Quoted 12 lines · Michael Walle

Hi Andrew,

Am Mittwoch 24 Oktober 2012, 16:53:45 schrieb Andrew Lunn:

Quoted 9 lines

This patchset converts all DT kirkwood boards to using pinctrl.

This patchset depends on an earlier patchset to allow the mvebu pinctrl driver and gpio driver to be built for kirkwood.

Only the TS219 conversion has been tested on hardware. The remaining are compile tested. Before merging upstream, it would be good if the others could be tested on hardware.

Quoted 6 lines
Quoted 1 line

This series along with the dependents can be found in:

Unfortunately, this doesn't work for me. git bisect tells me its commit e01139ec82162f21875d09e820686aede4219695.

I guess it has something to do with the lsxl_init calling gpio_set_value().

Humm.

I guess it is too early to use gpio. I don't think the gpio driver has not been configured yet.

I need to think about this.

What happens if you comment out these two gpio_set_value calls?

Andrew

Read the cover letter in its thread