ARM: Kirkwood: Convert to pinctrl
Get series with b4
b4 am [email protected]Versions newest first
- v1 Latest1 of 9 patches 0 repliesNew
1 of 9 patches is in this archive. The cover letter announces 9.
Patches in v1 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 7/9 | ARM: Kirkwood: Convert ib62x0 to pinctrl. | +0 | 0 replies |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [PATCH 0/9] ARM: Kirkwood: Convert to pinctrl
Hi Andrew,
Quoted 6 lines · Andrew Lunn
Quoted 1 line · Andrew Lunn
This patchset converts all DT kirkwood boards to using pinctrl.
I still expect problems with GPIOs used for power off. I've not yet touched them. Again, a regulator makes sense, but there is no 'out of the box' regulator type or property which adds itself to
pm_power_off.
the IB-NAS 62x0 works with the exception of the power off via GPIO. Additionally, the original U-Boot enables hardware blinking for the power led and Jamie's patch might be needed here as well. However, I don't use this U-Boot anymore and can't test this.
- Simon