ARM: Kirkwood: Convert to pinctrl
Get series with b4
b4 am [email protected]Versions newest first
- v1 Latest0 of 9 patches 0 repliesNew
Patches in v1 No applies recorded yet
None of the 9 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [PATCH 0/9] ARM: Kirkwood: Convert to pinctrl
Quoted 6 lines · Simon Baatz
Hi Andrew,
Quoted 3 lines · Andrew Lunn
Quoted 1 line · Andrew Lunn
This patchset converts all DT kirkwood boards to using pinctrl.
Quoted 8 lines
Quoted 3 lines
I still expect problems with GPIOs used for power off. I've not yet touched them. Again, a regulator makes sense, but there is no 'out of the box' regulator type or property which adds itself to
pm_power_off.the IB-NAS 62x0 works with the exception of the power off via GPIO. Additionally, the original U-Boot enables hardware blinking for the power led and Jamie's patch might be needed here as well. However, I don't use this U-Boot anymore and can't test this.
Hi Simon
Thanks for testing.
I hope Thomas Petazzoni will pickup the blinking patch and make sure its O.K. for 370/XP. It can then be merged in.
power off via GPIO is next on my list of things to solve.
Andrew