SERIAL: OMAP: Remove idle handling from driver
Get series with b4
b4 am [email protected]Versions newest first
- v1 Latest1 of 2 patches 0 repliesNew
1 of 2 patches is in this archive. The cover letter announces 2.
Patches in v1 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 1/2 | ARM: OMAP2+: hwmod-data: UART IP needs software control of sidle modes | +0 | 1 reply |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [RFC/RFT PATCH 0/2] SERIAL: OMAP: Remove idle handling from driver
Quoted 18 lines · Felipe Balbi
Quoted 17 lines · On Fri, Feb 15, 2013 at 06:33:58PM +0530, a0131647 wrote:
Hi,
Quoted 15 lines · Santosh Shilimkar
OMAP UART IP needs manual idle modes based on state of the IP. Currently this is handled by the driver with function pointers implemented in platform code.
This however breaks in case of device tree because of missing idle handling.
The series tries to address the issue
Patches has been tested on OMAP4 and OMAP5 devices where the console slugishness was observed without idle mode handling. CPUIDLE and suspend tested ok on these devices.
Need help in testing on OMAP2, OMAP3 and AM3XXX devices.
Quoted 7 lines
Quoted 5 lines
Tested this series on omap3630 beagle board for:
1. Retention in idle and suspend.
2. Off mode in idle and suspend.Tested-by Sourav Poddar <[email protected]>try setting
autosuspend_delayto -1
Also try DT boot and try to wakeup from echo mem > /sys/power/state by sending data through UART console.
Signature · 8 lines
balbi -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20130215/096d3ebe/attachment-0001.sig>