Skip to content

RFC ARM: omap3: add Seagate Wireless Plus board

Tony Lindgren linux-arm-kernel linux-omap 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 RFC Latest0 of 3 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 3 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [RFC PATCH 0/3] ARM: omap3: add Seagate Wireless Plus board
Quoted 6 lines · Jason Cooper

Current Problem:

There are several gaps in my understanding of how far along TI's conversion to DT is. Should I be doing a separate board file for initializing the legacy items? I was hoping to do it all with DT.

Sorry forgot to reply to this.. No seprate board file should be needed, some devices may still need to be initialized with pdata based on the compatible flag.

Quoted 7 lines

Obviously, I don't expect anybody to run out and buy one of these, take it apart, and try to boot this code. But if the omap guys could take a look at this and give me a few pointers, I'd appreciate it. I'm kind of spinning my wheels at the moment.

Primarily, I'd like to get nand and usb working, so that I can read/write, mount a rootfs and do better testing.

The USB should be doable with device tree. At least both echi and musb are working properly on pandaboard. I think people have been using NAND with the gpmc DT patches, but I don't know the current status for sure.

Is the hard drive on the EHCI bus or how is it connected to omap?

Regards,

Tony