Skip to content

Make mv_udc work for i.mx6

Marek Vasut u-boot 5 versions – New

Get series with b4
b4 am [email protected]

Versions newest first · linked by author and title

  1. v6 Latest1 of 10 patches 0 repliesNew
  2. v5 posting 2/24 of 18 patches 0 repliesSuperseded
  3. v5 posting 1/211 of 18 patches 0 repliesSuperseded
Earlier versions · 2
VersionPostedPatchesRepliesStatus
v311 of 20 patches0 repliesSuperseded
v1 RFC0 of 18 patches0 repliesSuperseded

1 of 10 patches is in this archive. The cover letter announces 10.

Patches in v6 No applies recorded yet

#Subject and filesSizeRepliesApplied
3/10usb: ehci-hcd: add enum usb_init_type parameter to ehci_hcd_init.+0 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v6 yet.

Read the v6 thread

Cover letter [U-Boot] [PATCH V6 00/10] Make mv_udc work for i.mx6

Dear Troy Kisky,

Quoted 21 lines

Hi Marek

This series is based on u-boot-usb/next branch.
After this series, nitrogen6x works with tftpboot to transfer files over usb, and will recognize a usb stick in the OTG port.

This V6 has been rebased to the latest u-boot-usb/next branch and changed to address Marek comments.

The most noticeable change is the addition of patches to use enum usb_init_type.

Tested on a Nitrogen6x board with the following commands when connected to a USB2.0 hub and a USB1.1 hub

setenv ipaddr 10.0.0.2 && setenv netmask 255.255.255.0 && setenv serverip 10.0.0.1 setenv usbnet_devaddr 00:11:22:33:44:55 && setenv usbnet_hostaddr 00:aa:bb:cc:dd:ee setenv ethprime usb_ether && setenv ethact usb_ether && setenv ncip 10.0.0.1 tftpboot 10800000 10.0.0.1:uImage6w

Quoted 4 lines

The USB1.1 had a transfer rate of 687.5 KiB/s, the USB2.0 hub had a transfer rate of 5.4 MiB/s.

And by recognizing a usb stick in each port.

Applied all, thanks.

Best regards,
Marek Vasut