ARM: OMAP2+: Remove remaining unused legacy code
Get series with b4
b4 am [email protected]Versions newest first · linked by author and title
- v1 Latest posting 2/21 of 3 patches 0 repliesNew
- v1 posting 1/20 of 3 patches 0 repliesSuperseded
1 of 3 patches is in this archive. The cover letter announces 3.
Patches in v1 posting 2/2 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 2/3 | ARM: OMAP2+: Remove unnecesary include in GPMC driver | +0 | 1 reply |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [RESEND PATCH 0/3] ARM: OMAP2+: Remove remaining unused legacy code
Quoted 9 lines · Javier Martinez Canillas
Once OMAP2+ board files are removed, there is unused code that was only used by legacy platform code and can be removed.
This patch-set depends on the series:
[PATCH 00/12] Drop omap3 board files and make mach-omap2 boot in DT only mode [0]
and is composed of the following patches:
Quoted 8 lines
[RESEND PATCH 1/3] ARM: OMAP2+: Remove legacy smsc911x and smc91x [RESEND PATCH 2/3] ARM: OMAP2+: Remove unnecesary include in GPMC [RESEND PATCH 3/3] ARM: OMAP2+: Remove legacy
board-flash.cTony,
I don't know what is your new schedule for board files removal but in case it is 3.16, I forward ported this patch-set on top of 3.14-rc7 and fixed some conflicts.
Thanks, I'll also rebase my changes in omap-for-v3.14/omap3-board-removal at some point. Probably a good target is v3.16 if the DSS changes go in. Then we just need displays enabled for omap3 and pandora supported to drop the legacy data AFAIK.
Regards,
Tony